13.33. The panel of devices

THE GENERAL DATA

Removal of the panel of devices

1 – intermediate screws, 2 – sheaves electric Wires,

3 – the forward screws placed in Motor compartment, 4 – lateral screws

MODELS TILL 1992

Removal

PERFORMANCE ORDER

1. To remove a negative wire from the accumulator. 2. To remove a steering wheel. 3. To remove casings of a steering column. 4. To remove a combination of devices. 5. To remove a radio receiver. 6. To unscrew screws of fastening and to remove wings from the central console. 7. To remove the proof-reader of light of headlights. 8. To remove an ashtray from a nest. 9. To unscrew two bolts (are specified by arrows at the left) in a nest of an ashtray and one bolt (it is specified by an arrow on the right) in a nest of installation of a radio receiver. 10. To unscrew two screws of fastening of the top part of a shelf. 11. To remove a forward part of the panel of devices. 12. To unscrew four screws (are specified by arrows), крепящие the heater panel. 13. To turn two brackets fastenings on a turn quarter, then to lower a box with fuses downwards from the panel. 14. To unscrew two bolts of fastening of the lever of opening of the cowl located under the panel. 15. To disconnect electroconducting from a rheostat of illumination of the instrument panel. 16. To disconnect two main sockets (are specified by arrows) from a box with fuses. 17. To disconnect from the left and right parties of a sheaf of wires of a combination of devices, having marked them for correct repeated installation. 18. To remove lateral forward furnish of salon from outside the driver and to unscrew a bolt (it is specified by an arrow) fastenings of the tyre of grounding. 19. To unscrew a bolt and to remove a suspension bracket of the relay from the bottom suspension bracket of a steering column. 20. In a back part of a motor compartment to unscrew three nuts (are specified by an arrow) fastenings of the panel of devices. 21. To unscrew bolts (on one on each party) the bottom fastening of the panel of devices (bolts are specified by an arrow). 22. To unscrew two bottom bolts of fastening of the panel of the devices located from two parties of the central console. 23. To unscrew the top bolt (it is specified by an arrow) fastenings of the panel of the devices, located for elements of management of heating and ventilation system. 24. To remove the strengthening which is between the panel of devices and the holder of elements of the mechanism of a gear change. 25. To remove a cable of a drive of a speedometer. 26. To take sheaves of electric wires of a combination of devices, and also management of system of heating and salon ventilation. 27. To disconnect electroconducting from the stoplight switch. 28. To disconnect electroconducting from cigarette Lighter and ashtray illuminations. 29. To remove the panel of devices and to take it from the car through a doorway.

Installation

PERFORMANCE ORDER

For installation of the panel of devices it is necessary to execute actions in return sequence in relation to process of removal and to check up, whether there are sealing linings on forward intermediate elements.

MODELS SINCE 1993

Removal

PERFORMANCE ORDER

1. To remove a negative wire from the accumulator. 2. To remove the central console. 3. To unscrew two screws (are specified by an arrow), the ashtrays located at the bottom of a nest. 4. To remove a radio receiver. 5. To unscrew two screws (are specified by an arrow) fastenings from the top part of a frame of a radio receiver. 6. To remove a radio receiver frame. 7. By means of a thin screw-driver to remove a decorative plate from the top corner of a frame of the central snuffled systems of ventilation and to unscrew opened screw (it is specified by an arrow). 8. To unscrew four screws of fastening the overlays located under the control panel heating and ventilation. Two screws are accessible from a forward part (drawing at the left) and two of the bottom part (drawing on the right). 9. By means of a thin screw-driver to remove the switches located under the central nozzles of system of ventilation and heating for access to the screw of fastening of the panel of devices. 10. To unscrew the screw of fastening of the panel of devices. 11. To extend the panel with ventilation nozzles forward, to disconnect electroconducting from hours and to remove the panel with ventilation nozzles. 12. To release brackets fastenings and to turn away a carpet covering over pedals. 13. To disconnect three electric sockets (are specified by arrows). 14. To unscrew the screw of fastening of furnish from outside the driver for access to an electric socket. 15. To remove the furnish panel. 16. To release two brackets fastenings and to remove electric sockets from a suspension bracket. To disconnect electric sockets. 17. To unscrew a bolt of fastening of the tyre of grounding and to release a plait of wires from скоб fastenings under the panel. 18. Under the central part of the panel to unscrew screws of fastening of lateral furnish of the central part of the panel. 19. To remove lateral furnish of the central part of the panel for access to heater air lines. 20. To unscrew screws and to remove air lines. 21. To remove a collar, securing the a plait of wires to a suspension bracket in the panel centre from outside the driver. 22. To release plastic brackets, крепящие the big block of a connector to a suspension bracket of the central part of the panel on the party of the driver, then to disconnect sockets from the connector block. 23. In the same way from outside the passenger to release plastic brackets, крепящие the connector block to a suspension bracket on a floor and to a heater. 24. To release brackets fastenings and to take a carpet covering from under the panel. 25. To unscrew the screw of fastening and to remove lateral furnish from outside the passenger, to release brackets fastenings and to take the block of a connector of electroconducting. To disconnect a socket from the connector block. 26. To unscrew a bolt of fastening of the tyre of grounding and to release a plait of wires from скоб fastenings. 27. To unscrew the screw and to remove the lever of opening of a cowl. 28. To remove casings of a steering column. 29. To remove a steering column. 30. To unscrew screws (fastenings are specified by arrows) and to remove a suspension bracket of a connector of electroconducting on the left side of a steering column. 31. To unscrew two screws of fastening and to remove a suspension bracket of a connector of electroconducting on the right side of a steering column. 32. To remove a combination of devices. 33. To disconnect a wire from the stoplight switch. 34. To disconnect the main connectors of a plait of wires from the block of the connector established under the panel from outside of the driver. 35. To unscrew the screw, securing the an electroconducting suspension bracket from outside the driver, near to a coupling pedal. 36. To take the relay from a socket in a back part of a suspension bracket of a steering column. 37. To remove a socket from a suspension bracket. 38. To remove the control panel a heater. 39. Working in a motor compartment, to remove a lattice located before a windscreen. 40. To remove bracket fastenings of a plastic board. 41. To take a plastic board from outside the passenger. 42. To remove a lattice of an air inlet of a heater and to move a casing of the block of management aside for access to nuts of fastening of the panel. 43. To unscrew bolts (on one on each party) the bottom fastening of the panel of devices. 44. To unscrew two bottom bolts of fastening of the panel of the devices located from two parties of the central console. 45. To unscrew the central top bolt of fastening of the panel, located over the block of management of a heater. 46. To unscrew two back central bolts of fastening of the panel to a heater. 47. In a back part of a motor compartment to unscrew three nuts (are specified by an arrow) fastenings of the panel of devices. 48. To move the panel from a partition of a motor compartment. 49. To disconnect a cable of a drive of a speedometer. 50. To take the panel of devices from the car.

Installation

For installation of the panel of devices it is necessary to execute actions in return sequence in relation to removal process.