Peugeot405
1. The maintenance instruction
2. Maintenance service
3. Engines
4. Fuel system
5. Systems of greasing, cooling
    5.1. Greasing system
      5.1.1. The oil pallet
      5.1.2. The oil pump
      5.1.3. An oil radiator
      5.1.4. Check of pressure of oil
    5.2. Cooling system
6. Release system
7. Coupling
8. Transmissions
9. Power shafts
10. A steering
11. Suspension brackets
12. Brake system
13. A body
14. An electric equipment


5. Systems of greasing, cooling

5.1. Greasing system

5.1.1. The oil pallet
THE GENERAL DATA

Greasing system

1 – the oil pump,

2 – an asterisk of the oil pump,

3 – маслоприемник,

4 – a chain of a drive of the pump,

5 – the oil pallet,

6 – a drain stopper of oil,

7 – the oil filter,

8 – the index of level of oil,

9 – the gauge of pressure of oil,


10 – the jellied oil pipeline,

11 – a jellied mouth of oil


Removal

PERFORMANCE ORDER
1. To remove a wire of weight from the accumulator and to merge oil from the engine.
2. To tighten a manual brake and to lift a forward part of the car.
3. On models with an air conditioning where the compressor is established from outside the pallet to remove driving a belt. To unscrew a bolt of the compressor and to fix the compressor to a body. Not to unscrew from the compressor pipelines.
4. To disconnect a wire from the gauge of temperature of oil which is screwed in in the pallet.
5. To unscrew bolts of fastening and to remove the pallet. Bolts of fastening of the pallet have different length, therefore they are necessary for placing so that at installation they have fallen into place.
6. To check up a condition of the oil pump and the mesh filter маслозаборника.
7. On some models with the engine of 1905 sm3 with 16 valves the big plate between the pallet and the block of cylinders which fastens two screws on a plate diagonal is established.

The engine with the removed pallet


Installation

PERFORMANCE ORDER
1. To clear all traces of a lining on the pallet and the block of cylinders and to wipe them dry.
2. To put on a lining a thin layer of hermetic, to establish it on the pallet.
3. The pallet with a lining to establish on the engine and to screw bolts.
4. On models with the aluminium pallet (without a lining) to clear surfaces the pallet and the block of cylinders and to wipe them dry.
5. To put on the pallet a thin layer of hermetic and to establish it on the engine.
6. To establish the air conditioning compressor on the pallet.
7. To establish driving a belt.
8. To establish a wire on the gauge of temperature of oil.
9. To lower the car and to fill in engine oil in the engine.