Фунция записи, запись по таймеру на жесткий диск доступно для триколор в городе Краснодар.

1. The maintenance instruction
2. Maintenance service
3. Engines
4. Fuel system
5. Systems of greasing, cooling
6. Release system
7. Coupling
8. Transmissions
9. Power shafts
   9.1. A technical characteristics
   9.2. Removal of power shafts
   9.3. Power shaft installation
   9.4. Replacement of covers of hinges of equal angular speeds
   9.5. Replacement of the intermediate bearing of the right power shaft
   9.6. A drive on forward wheels with the power unit 4 х 4
   9.7. A drive on back wheels with the power unit 4 х 4
10. A steering
11. Suspension brackets
12. Brake system
13. A body
14. An electric equipment

9. Power shafts

Kind of a forward suspension bracket with power shafts and steering system
Power shafts

1 – a connecting shaft of a right power shaft,
2 – a right power shaft,
3 – external hinges,
4 – internal hinges,
5 – a left power shaft,
6 – nuts of naves,
7 – an element of protection of a nut from отворачивания,
8 – pin,
9 – an external cover,
10 – an internal cover

The twisting moment from the engine is transferred to forward wheels through two steel power shafts of different length.

The external ends of power shafts are inserted in a nave of a wheel and fixed by nuts. The internal ends of power shafts are established and fixed in differential.

Hinges of equal angular speeds (SHRUS) are established from two parties of power shafts and provide smooth and effective transfer of a twisting moment at work of a suspension bracket and turn of forward wheels. The external SHRUS consists of the case, a separator, an internal holder and balls. In the case of the hinge and a holder flutes for placing of balls are made. Flutes of a longitudinal plane are executed on radius that provides the big angle of rotation of the external hinge. The internal hinge differs from external that instead of balls the rollers fixed on приводном to a shaft are used.

On the right side because of the big length of a power shaft the internal hinge is located approximately on the middle of length of a shaft, and the intermediate bearing of support is fixed in a suspension bracket of installation of the power unit.