9.6. A drive on forward wheels with the power unit 4 х 4

THE GENERAL DATA

Drive elements on back wheels (version 4 х 4)

1 – a forward shaft, 2 – a back shaft, 3 – a holder, 4 – the hinge, 5 – the intermediate bearing, 6 – картер back driving the bridge, 7 – a connector of an exit of the bridge, 8 – a ring, 9, 10 – sealing rings, 11 – a closing plate,

12 – a back arm of the bridge, 13 – a metallo-rubber element, 14, 15 – power shafts of back wheels, 16 – the case of the hinge, 17 – a separator, 18 – a holder, 19 – a casing приводных hinges, 20 – a nut, 21 – a protective casing

Because of use of a distributing box and differential moving on the right party of the car knots of power shafts have a specific design. On the right side there is no intermediate bearing. The removal method is identical to both parties.

Separate recommendations

Left-hand side: plums of oil from a transmission it is not obligatory.

The right party: it is necessary to incline slightly the car on a left-hand side to avoid leakage some oil from a distributing box.

In the cars equipped with antiblocking system of brakes, it is necessary to disconnect the wheel gauge (from the corresponding party).

To execute actions, as for the car with a drive on forward wheels (the right party).

In an installation time it is necessary to grease a basic surface of a shaft of the left semiaxis on an exit of a transmission with greasing Molykote BR2 Plus and to replace a sealing ring of an exit of a distributing box on the right side.