Peugeot405
1. The maintenance instruction
2. Maintenance service
3. Engines
4. Fuel system
5. Systems of greasing, cooling
6. Release system
7. Coupling
8. Transmissions
9. Power shafts
10. A steering
11. Suspension brackets
12. Brake system
   12.1. A technical characteristics
   12.2. Prorolling of hydraulic brake system
   12.3. Replacement of lobbies brake pads
   12.4. Brake pipelines and hoses
   12.5. Replacement back brake pads on disk brakes
   12.6. Replacement back brake pads on drum-type brakes
   12.7. A forward brake disk
   12.8. A back brake disk
   12.9. A back brake drum
   12.10. A support of a forward brake
   12.11. A support of a back wheel
   12.12. The back brake cylinder
   12.13. The main brake cylinder
   12.14. A brake pedal
   12.15. The vacuum amplifier of brakes
   12.16. The unilateral valve of the vacuum amplifier of brakes
   12.17. Adjustment of a manual brake
   12.18. The lever of a manual brake
   12.19. A cable of a manual brake
   12.20. The switch of a control lamp of inclusion of a manual brake
   12.21. The valve of adjustment of pressure in brake system
   12.22. The stoplight switch
   12.23. Antiblocking system (ABS)
   12.24. Replacement of the gauge of a wheel
   12.25. Removal of air from brake system
13. A body
14. An electric equipment


12.24. Replacement of the gauge of a wheel
PERFORMANCE ORDER
1. To establish the car on the lift.
2. To unscrew a bolt of fastening of the gauge.
3. To disconnect the electric socket which is in front on a rack of a suspension bracket.
4. To disconnect the electric socket which is behind on a lateral wall of a luggage carrier, on the corresponding party.
5. To check up a condition of a cogwheel and a working surface of the gauge.

The prevention

New gauges are delivered together with самоклеющейся a plate on a working surface. This plate before installation is necessary for removing necessarily.


6. To establish the gauge in a nest and to fix a bolt (this bolt before installation it is necessary to grease with means Loctite Frenetanch).
7. To check up size of an air backlash between the gauge and a cogwheel which should make 0,5 mm.
8. To check up a gauge signal.
9. On models with system Bendix with ABS to execute following actions.
10. To weaken a bolt of a regulator of the gauge.
11. To place щуп in the thickness of 0,5 mm between a tip of the gauge and a gauge ring on приводном to a shaft.
12. To press the gauge aside щупа, to tighten a bolt of a regulator the demanded moment.
13. To remove щуп.