Peugeot405
1. The maintenance instruction
2. Maintenance service
3. Engines
4. Fuel system
5. Systems of greasing, cooling
6. Release system
7. Coupling
8. Transmissions
9. Power shafts
10. A steering
11. Suspension brackets
12. Brake system
   12.1. A technical characteristics
   12.2. Prorolling of hydraulic brake system
   12.3. Replacement of lobbies brake pads
   12.4. Brake pipelines and hoses
   12.5. Replacement back brake pads on disk brakes
   12.6. Replacement back brake pads on drum-type brakes
   12.7. A forward brake disk
   12.8. A back brake disk
   12.9. A back brake drum
   12.10. A support of a forward brake
   12.11. A support of a back wheel
   12.12. The back brake cylinder
   12.13. The main brake cylinder
   12.14. A brake pedal
   12.15. The vacuum amplifier of brakes
   12.16. The unilateral valve of the vacuum amplifier of brakes
   12.17. Adjustment of a manual brake
   12.18. The lever of a manual brake
   12.19. A cable of a manual brake
   12.20. The switch of a control lamp of inclusion of a manual brake
   12.21. The valve of adjustment of pressure in brake system
   12.22. The stoplight switch
   12.23. Antiblocking system (ABS)
   12.24. Replacement of the gauge of a wheel
   12.25. Removal of air from brake system
13. A body
14. An electric equipment


12.12. The back brake cylinder
THE GENERAL DATA

Back working brake cylinder Girling with a pressure regulator


Back working brake cylinder Bendix with a pressure regulator

1 – the cylinder,

2 – a bolt of fastening,

3 – the union of prorolling,

4 – a repair set

Arrangement of a nut of fastening of a brake tube and bolts of fastening of the working brake cylinder

And – a nut of fastening of a brake tube

In – bolts of fastening of the working brake cylinder

Removal

PERFORMANCE ORDER
1. To remove a brake drum.
2. Using flat-nose pliers, to remove the top spring compressing brake pads.
3. To remove the top ends brake pads from pistons of the working brake cylinder.
4. Using a G-shaped clip, to press a brake hose in a place closest to the working brake cylinder.
5. To remove a dirt round a junction of a brake hose and a back part of the working brake cylinder.
6. To unscrew a connecting nut.
7. Being careful to take a brake pipe from the working brake cylinder.
8. To close a tube and the brake cylinder stoppers.
9. To unscrew two bolts of fastening of the working brake cylinder to a brake board.
10. Being careful to remove the working brake cylinder.

Repair

If the brake cylinder has defects, it is necessary to replace it completely since separate parts for it are not delivered.

Installation

PERFORMANCE ORDER
1. To check up that interfaced surfaces on a brake board and the working brake cylinder the pure.
2. To establish the brake cylinder into place.
3. To establish a brake pipe in the brake cylinder and on 2–3 turns to screw a connecting nut.
4. To screw in two bolts of fastening of the working brake cylinder to a brake board, and to tighten their demanded moment.
5. Definitively to tighten a nut of fastening of a brake pipe to the working brake cylinder.
6. To remove a clip from a brake hose.
7. To establish the top parts brake pads in grooves of the piston of the working brake cylinder.
8. To establish the top returnable spring brake pads.
9. To establish a brake drum.
10. To remove air from brake system.