Peugeot405
1. The maintenance instruction
2. Maintenance service
3. Engines
4. Fuel system
5. Systems of greasing, cooling
6. Release system
7. Coupling
8. Transmissions
9. Power shafts
10. A steering
11. Suspension brackets
12. Brake system
   12.1. A technical characteristics
   12.2. Prorolling of hydraulic brake system
   12.3. Replacement of lobbies brake pads
   12.4. Brake pipelines and hoses
   12.5. Replacement back brake pads on disk brakes
   12.6. Replacement back brake pads on drum-type brakes
   12.7. A forward brake disk
   12.8. A back brake disk
   12.9. A back brake drum
   12.10. A support of a forward brake
   12.11. A support of a back wheel
   12.12. The back brake cylinder
   12.13. The main brake cylinder
   12.14. A brake pedal
   12.15. The vacuum amplifier of brakes
   12.16. The unilateral valve of the vacuum amplifier of brakes
   12.17. Adjustment of a manual brake
   12.18. The lever of a manual brake
   12.19. A cable of a manual brake
   12.20. The switch of a control lamp of inclusion of a manual brake
   12.21. The valve of adjustment of pressure in brake system
   12.22. The stoplight switch
   12.23. Antiblocking system (ABS)
   12.24. Replacement of the gauge of a wheel
   12.25. Removal of air from brake system
13. A body
14. An electric equipment


12.18. The lever of a manual brake
THE GENERAL DATA

Arrangement of nuts of fastening of the lever of a manual brake

1 – the lever,

2 – the holder,

3 – a cable tip

Removal and installation

PERFORMANCE ORDER
1. To disconnect a back part of a forward cable of a manual brake from the right back cable under the car.
2. On models with the usual central console to tighten the lever of a manual brake, and to remove furnish of a manual brake from the top part of the central console.
3. To remove furnish on the lever of a manual brake.
4. On models with the improved central console to remove the central console.
5. Under the car, for access to nuts of fastening of the lever of a manual brake to remove an intermediate link of an exhaust system and a heat resisting guard.
6. To unscrew four nuts of fastening of the lever of a manual brake.
7. To lower the lever of a manual brake under the car and to disconnect a wire from the switch of a control lamp of inclusion of a manual brake.
8. To disconnect a cable of a manual brake from the lever.
9. Installation is made in sequence of return to removal.
10. To check up and if necessary to adjust work of a manual brake.