Peugeot405
1. The maintenance instruction
2. Maintenance service
3. Engines
4. Fuel system
5. Systems of greasing, cooling
6. Release system
7. Coupling
8. Transmissions
9. Power shafts
10. A steering
11. Suspension brackets
12. Brake system
   12.1. A technical characteristics
   12.2. Prorolling of hydraulic brake system
   12.3. Replacement of lobbies brake pads
   12.4. Brake pipelines and hoses
   12.5. Replacement back brake pads on disk brakes
   12.6. Replacement back brake pads on drum-type brakes
   12.7. A forward brake disk
   12.8. A back brake disk
   12.9. A back brake drum
   12.10. A support of a forward brake
   12.11. A support of a back wheel
   12.12. The back brake cylinder
   12.13. The main brake cylinder
   12.14. A brake pedal
   12.15. The vacuum amplifier of brakes
   12.16. The unilateral valve of the vacuum amplifier of brakes
   12.17. Adjustment of a manual brake
   12.18. The lever of a manual brake
   12.19. A cable of a manual brake
   12.20. The switch of a control lamp of inclusion of a manual brake
   12.21. The valve of adjustment of pressure in brake system
   12.22. The stoplight switch
   12.23. Antiblocking system (ABS)
   12.24. Replacement of the gauge of a wheel
   12.25. Removal of air from brake system
13. A body
14. An electric equipment


12.13. The main brake cylinder

Removal

PERFORMANCE ORDER
1. To remove a wire of weight from the accumulator.
2. To remove a stopper from a tank of the main brake cylinder, the filter and to pump out a liquid from a tank.
3. To remove levers of a cleaner of a windscreen.
4. To remove a partition lattice under a windscreen.
5. To disconnect an electric socket from the gauge of level of a brake liquid.
6. To unscrew two nuts of fastening of the main brake cylinder to the vacuum amplifier.
7. To clear a dirt of junctions of brake tubes to the main brake cylinder, to enclose rags under places of connections, to collect the flowed out brake liquid.
8. To unscrew nuts of fastening of brake tubes to the main brake cylinder.
9. To remove the main brake cylinder with a nutritious tank.
10. To unscrew a tightening nut and a bolt and to remove a tank from the main brake cylinder and to take sealing rings from windows of the main brake cylinder.

Repair

Repair of the main brake cylinder can be made only in the presence of the repair complete set of details. At repair of the main brake cylinder to pay attention to an arrangement of all elements repeatedly to establish them on the places. At assemblage of the main brake cylinder to grease all details and sealing rings with a pure brake liquid.

Repair of the main brake cylinder to make according to the instruction enclosed to the repair complete set of details.

Installation

PERFORMANCE ORDER
1. Installation is made in sequence of return to removal taking into account following moments.
2. If sealing rings have defects, it is necessary to replace them.
3. To check up that connections of brake pipelines are reliably tightened.
4. To establish screen wiper levers.
5. To fill in a brake liquid and to remove air from brake system.