Peugeot405
1. The maintenance instruction
2. Maintenance service
3. Engines
4. Fuel system
5. Systems of greasing, cooling
6. Release system
7. Coupling
8. Transmissions
9. Power shafts
10. A steering
11. Suspension brackets
12. Brake system
   12.1. A technical characteristics
   12.2. Prorolling of hydraulic brake system
   12.3. Replacement of lobbies brake pads
   12.4. Brake pipelines and hoses
   12.5. Replacement back brake pads on disk brakes
   12.6. Replacement back brake pads on drum-type brakes
   12.7. A forward brake disk
   12.8. A back brake disk
   12.9. A back brake drum
   12.10. A support of a forward brake
   12.11. A support of a back wheel
   12.12. The back brake cylinder
   12.13. The main brake cylinder
   12.14. A brake pedal
   12.15. The vacuum amplifier of brakes
   12.16. The unilateral valve of the vacuum amplifier of brakes
   12.17. Adjustment of a manual brake
   12.18. The lever of a manual brake
   12.19. A cable of a manual brake
   12.20. The switch of a control lamp of inclusion of a manual brake
   12.21. The valve of adjustment of pressure in brake system
   12.22. The stoplight switch
   12.23. Antiblocking system (ABS)
   12.24. Replacement of the gauge of a wheel
   12.25. Removal of air from brake system
13. A body
14. An electric equipment





12.21. The valve of adjustment of pressure in brake system
THE GENERAL DATA

The prevention

The valve of adjustment of pressure in brake system is located on the right party of assemblage of a back axis. On some models with back drum-type brakes valves are combined with working brake cylinders.

Do not try to remove the valve for pressure adjustment on the models equipped with brakes Bendix with ABS. This work is necessary for carrying out at servicing deport.

At installation on a former place, the valve should be adjusted, with use of the special equipment.


Removal and installation

PERFORMANCE ORDER
1. To lift a back part of the car and to fix on supports.
2. To disconnect a spring of a drive of the valve from a suspension bracket.
3. To unscrew connecting nuts and to disconnect brake pipes from the valve.
4. To unscrew bolts of fastening of the valve and to take the valve from under the car.
5. Installation is made in sequence of return to removal.
6. To remove air from brake system and to adjust the valve at servicing deport.