Peugeot405
1. The maintenance instruction
2. Maintenance service
3. Engines
4. Fuel system
5. Systems of greasing, cooling
6. Release system
7. Coupling
8. Transmissions
9. Power shafts
10. A steering
11. Suspension brackets
12. Brake system
   12.1. A technical characteristics
   12.2. Prorolling of hydraulic brake system
   12.3. Replacement of lobbies brake pads
   12.4. Brake pipelines and hoses
   12.5. Replacement back brake pads on disk brakes
   12.6. Replacement back brake pads on drum-type brakes
   12.7. A forward brake disk
   12.8. A back brake disk
   12.9. A back brake drum
   12.10. A support of a forward brake
   12.11. A support of a back wheel
   12.12. The back brake cylinder
   12.13. The main brake cylinder
   12.14. A brake pedal
   12.15. The vacuum amplifier of brakes
   12.16. The unilateral valve of the vacuum amplifier of brakes
   12.17. Adjustment of a manual brake
   12.18. The lever of a manual brake
   12.19. A cable of a manual brake
   12.20. The switch of a control lamp of inclusion of a manual brake
   12.21. The valve of adjustment of pressure in brake system
   12.22. The stoplight switch
   12.23. Antiblocking system (ABS)
   12.24. Replacement of the gauge of a wheel
   12.25. Removal of air from brake system
13. A body
14. An electric equipment


12.14. A brake pedal
THE GENERAL DATA

The prevention

On models with brakes of type Bendix with ABS, it is necessary to remove the hydraulic modulator.


Removal

PERFORMANCE ORDER
1. To remove the vacuum amplifier of brakes.
2. To remove bracket fastenings and to take a pin with a head and an aperture under pin, securing the a pusher of a pedal of a brake with the vacuum amplifier.
3. To unscrew a nut swivel a bolt and to remove a brake pedal from the car.

Installation

PERFORMANCE ORDER
1. To grease with universal greasing a lining and to insert it into an aperture of a point of turn of a pedal.
2. To establish a brake pedal into place. Thus to check up, that the pusher became on the place.
3. To insert шарнирный a bolt and to fix a nut.
4. To combine a pedal with a pusher and to insert a pin with a head and an aperture under pin and to fix it bracket.
5. The further installation is made in sequence, return to removal.