Peugeot405
1. The maintenance instruction
2. Maintenance service
3. Engines
4. Fuel system
5. Systems of greasing, cooling
6. Release system
7. Coupling
8. Transmissions
    8.1. A mechanical transmission
      8.1.1. A technical characteristics
      8.1.2. Oil replacement in a transmission
      8.1.3. Adjustment of draught of a gear change
      8.1.4. The gear change lever
      8.1.5. Draught of a gear change
      8.1.6. A cable of blocking of inclusion of a reverse gear
      8.1.7. Sealing rings
      8.1.8. The switch of a lantern of a backing
      8.1.9. A speedometer drive
      8.1.10. Removal and transmission installation
      8.1.11. Transmission dismantling
      8.1.12. Differential repair
      8.1.13. Repair of a primary shaft
      8.1.14. Repair of a secondary shaft
      8.1.15. Transmission assemblage
      8.1.16. Definition of a tightness of the conic bearing of a primary shaft
      8.1.17. The strengthened sealing rings
      8.1.18. Distinctive features of a drive 4 х 4
      8.1.19. A distributing box of system of a drive 4 х 4
    8.2. An automatic transmission
9. Power shafts
10. A steering
11. Suspension brackets
12. Brake system
13. A body
14. An electric equipment


8.1.5. Draught of a gear change Removal

PERFORMANCE ORDER
1. To unscrew and take a bolt of a plug of the lever of a gear change on the bottom part of a control lever a transmission. The bolt is accessible through apertures sideways a plastic casing of support of a control lever a transmission.
2. To unscrew a bolt from a plug on шарнирных connections and to disconnect draught from the angular lever.
3. To shift a rubber cover from draught and to take draught in car salon, thus it is necessary to remove one of forward seats.
4. To lift a forward part of the car and to fix on supports.
5. The angular lever and шарнирное connection are established on a casing of a shelf of management. For assemblage removal to disconnect a plug from the end of draught and to disconnect draughts from spherical шарнирных connections.
6. To remove a head with swivel a bolt of the angular lever, to unscrew a bolt and to remove assemblage of the angular lever.
7. To examine all elements of draught on deterioration or damages, paying special attention on plugs of points of turn, and to replace the worn out details if necessary.

Installation

PERFORMANCE ORDER
Installation is made in sequence of return to removal, thus to put a small layer of greasing on a sealing ring of a partition, to facilitate draught installation through a sealing ring. To check up that the sealing ring was not displaced in the course of draught installation.