Peugeot405
1. The maintenance instruction
2. Maintenance service
3. Engines
4. Fuel system
5. Systems of greasing, cooling
6. Release system
7. Coupling
8. Transmissions
    8.1. A mechanical transmission
      8.1.1. A technical characteristics
      8.1.2. Oil replacement in a transmission
      8.1.3. Adjustment of draught of a gear change
      8.1.4. The gear change lever
      8.1.5. Draught of a gear change
      8.1.6. A cable of blocking of inclusion of a reverse gear
      8.1.7. Sealing rings
      8.1.8. The switch of a lantern of a backing
      8.1.9. A speedometer drive
      8.1.10. Removal and transmission installation
      8.1.11. Transmission dismantling
      8.1.12. Differential repair
      8.1.13. Repair of a primary shaft
      8.1.14. Repair of a secondary shaft
      8.1.15. Transmission assemblage
      8.1.16. Definition of a tightness of the conic bearing of a primary shaft
      8.1.17. The strengthened sealing rings
      8.1.18. Distinctive features of a drive 4 х 4
      8.1.19. A distributing box of system of a drive 4 х 4
    8.2. An automatic transmission
9. Power shafts
10. A steering
11. Suspension brackets
12. Brake system
13. A body
14. An electric equipment


8.1.12. Differential repair
THE GENERAL DATA

Differential

1 – a sealing ring,
2 – a regulating lining,
3 – bearings,
4 – a box of differential,
5 – a wheel of main transfer, 		6 – a sealing ring,
7 – an axis of satellites,
8 – a pin of fastening of an axis of satellites,
9 – a lining of a centering of a cogwheel

Выбивание a pin of fastening of an axis of satellites


Removal of the bearing from a differential box


PERFORMANCE ORDER
1. To beat out a pin of fastening of an axis of satellites, and then to remove an axis and satellites.
2. To remove a gear wheel of the main transfer. To remove bearings from a differential box, thus it is necessary to use a universal stripper.
3. To replace bearings on new, thus to use the adaptation 80317 D and a press.
4. To establish gear wheels, and then the adaptation holding gear wheels from their loss. In drawing installation of satellites with new rings of sliding is shown.
5. To establish a gear wheel of the main transfer. The facet of a gear wheel of the main transfer should be from outside differential boxes. Bolts it is necessary to tighten the moment of 65 Nanometers.