8.1.2. Oil replacement in a transmission

THE GENERAL DATA

Plums of oil from a transmission will be faster and effective if this operation to make after warming up of the engine to working temperature and carrying out of a control trip for transmission warming up.

PERFORMANCE ORDER

1. To lift the car on the lift or to establish over a viewing hole. 2. On the cars equipped with transmission ВЕ3 to remove the left forward wheel to unscrew screws and to remove protection of an arch of a wheel from under a wing for access to a stopper of pouring of oil. On all models to remove a mudguard from under the engine. 3. To wipe area round a stopper of pouring of oil. On transmission ВЕ3 the stopper of pouring of oil is the biggest bolt among bolts of fastening of a face cover to a transmission. On transmission ВЕ1 the stopper of pouring of oil is located on a back part of a casing of differential. To unscrew a stopper of pouring of oil from a transmission. 4. To establish the corresponding container under маслосливной a stopper (it is specified by an arrow), transmission ВЕ located in a back part or the left forward party of differential of transmission МА and to unscrew a stopper. 5. Completely to merge oil from a transmission. To clear a stopper of pouring of oil (it is specified by an arrow) and маслосливную a stopper from metal particles and to replace sealing washers. 6. To screw up маслосливную a stopper and to tighten its demanded moment. 7. To fill in oil in a transmission to bottom edge level маслозаливного apertures. The prevention For correct filling of a transmission the car should be in horizontal position. 8. To screw up a stopper of pouring of oil, to establish a wheel and to make a short trip and repeatedly to check up oil level. 9. If necessary to modify oil level, to establish a new sealing washer on a stopper, to screw in a stopper into place and to tighten the demanded moment. To establish protection of an arch of a wheel and an engine mudguard.