Peugeot405
1. The maintenance instruction
2. Maintenance service
3. Engines
4. Fuel system
5. Systems of greasing, cooling
6. Release system
7. Coupling
8. Transmissions
    8.1. A mechanical transmission
      8.1.1. A technical characteristics
      8.1.2. Oil replacement in a transmission
      8.1.3. Adjustment of draught of a gear change
      8.1.4. The gear change lever
      8.1.5. Draught of a gear change
      8.1.6. A cable of blocking of inclusion of a reverse gear
      8.1.7. Sealing rings
      8.1.8. The switch of a lantern of a backing
      8.1.9. A speedometer drive
      8.1.10. Removal and transmission installation
      8.1.11. Transmission dismantling
      8.1.12. Differential repair
      8.1.13. Repair of a primary shaft
      8.1.14. Repair of a secondary shaft
      8.1.15. Transmission assemblage
      8.1.16. Definition of a tightness of the conic bearing of a primary shaft
      8.1.17. The strengthened sealing rings
      8.1.18. Distinctive features of a drive 4 х 4
      8.1.19. A distributing box of system of a drive 4 х 4
    8.2. An automatic transmission
9. Power shafts
10. A steering
11. Suspension brackets
12. Brake system
13. A body
14. An electric equipment


8.1.11. Transmission dismantling
PERFORMANCE ORDER
1. To establish a transmission on a desktop.
2. To remove a back cover.
3. To note position of a nave of the synchronizer of 5 transfers concerning sliding муфты the synchronizer.
4. To include 5 transfer and to take an axis of a plug of 5 transfers.
5. For blocking of shaft to include by means of the selector two transfers simultaneously.
6. To unscrew a nut of a primary shaft (12-faced накидным a key of 28 mm).
7. To take knot a nave-sliding муфта and a plug of 5 transfers.
8. To remove a ball and a spring, and then to place on a corresponding place sliding муфту on a nave.
9. To include 5 transfer and to unscrew a nut of a secondary shaft (12-faced накидным a key of 28 mm).
10. For blocking of shaft to include by means of the selector two transfers simultaneously.
11. To remove sliding муфту and its nave, a gear wheel of 5 transfers, its plug and a remote ring.
12. To remove a gear wheel of 5 transfers of a secondary shaft.
13. To take a clamp of fastening of a motionless axis of 1-2 and 3–4 transfers.
14. To unscrew bolts of fastening of the bearing.
15. To remove a spring ring of the bearing of a secondary shaft, to unscrew fastening bolts картера transmissions, and then to remove картер.
16. To remove a magnetised plate.
17. To take a selector axis, to remove a spring ring together with a lining and a round sealing ring.
18. To beat out a pin of an axis of the selector.
19. To include a reverse gear, and then to take an axis and a reverse gear gear wheel.
20. To take knot of gear wheels together with plugs.
21. To take a reverse gear frame.
22. To unscrew three bolts of fastening of the directing plug выжимного the bearing, to remove regulating lining and an external ring.
23. To remove a gear wheel of a drive of a speedometer together with the case, a lead, a round sealing ring and regulating lining.
24. To remove the external case of differential, and then differential. To designate external rings concerning bearings.
25. To take a special lining of an axis of the selector.
26. To remove a finger of the selector and a stopper closing an axis.
27. To clear surfaces of connection of cases.