14.8. Bulbs of internal illumination

THE GENERAL DATA

---

The prevention

Before replacement of bulbs of internal illumination to check up a corresponding electric chain and a safety lock.

---

LAMPS OF ILLUMINATION OF SALON, WARE BOX AND LUGGAGE CARRIER ILLUMINATION

PERFORMANCE ORDER

1. Using a thin screw-driver, to remove a plafond from an illumination lantern. 2. In certain cases for plafond removal it is necessary to remove an illumination lantern. 3. For bulb extraction to press it, in this position to turn in any party and to take from the holder. 4. Installation is made in sequence, return to removal.

CEILING LAMP

PERFORMANCE ORDER

1. Using a thin screw-driver, to remove a lantern of illumination from the top console on a ceiling. 2. To remove a lamp накаливания, fixed between spring contacts. 3. Installation is made in sequence, return to removal.

ILLUMINATION OF THE BLOCK OF MANAGEMENT BY THE HEATER (MODELS TILL 1992)

PERFORMANCE ORDER

For access to lamps накаливания to remove the block of management of a heater without a detachment of cables of management.

ILLUMINATION OF THE BLOCK OF MANAGEMENT BY THE HEATER (MODELS SINCE 1993)

PERFORMANCE ORDER

1. To remove a negative wire from the accumulator. 2. To remove the central console. 3. To unscrew two screws located at the bottom of a casing of an ashtray. 4. To remove a radio receiver. 5. To unscrew two screws of fastening from the top part of a frame of a radio receiver. 6. By means of a thin screw-driver to remove a decorative plate from the top corner of a frame of the central snuffled systems of ventilation and to unscrew opened screw. 7. To unscrew four screws of fastening the overlays located under the control panel heating and ventilation. Two screws are accessible from a forward part and two of the bottom part. 8. For access to the screw of fastening of the panel of devices by means of a thin screw-driver to remove the switches located under the central nozzles of system of ventilation and heating. To unscrew the screw. 9. To extend the panel with ventilation nozzles forward, to disconnect electroconducting from hours and to remove the panel with ventilation nozzles. 10. To remove handles of management of a heater. 11. To remove передную the panel from the block of management of a heater for access to lamps накаливания. 12. For bulb extraction to press it, in this position to turn in any party and to take from the holder. 13. Installation is made in sequence, return to removal.

LAMP OF ILLUMINATION OF HOURS

PERFORMANCE ORDER

1. For access to a lamp накаливания illumination of hours to remove hours. 2. For lamp removal накаливания to turn a cartridge with a bulb counter-clockwise and to take a bulb from hours. 3. Installation is made in sequence, return to removal.

LAMPS OF ILLUMINATION OF SWITCHES ON THE PANEL

Lamps накаливания compound with switches also cannot be replaced separately.

ILLUMINATION OF THE COMBINATION OF DEVICES

PERFORMANCE ORDER

1. To remove a combination of devices. 2. For lamp removal накаливания to turn a cartridge with a bulb counter-clockwise and to take a bulb from a combination of devices, simply having pulled it on itself. 3. Installation is made in sequence, return to removal.