Peugeot405
1. The maintenance instruction
2. Maintenance service
3. Engines
4. Fuel system
5. Systems of greasing, cooling
6. Release system
7. Coupling
8. Transmissions
9. Power shafts
10. A steering
11. Suspension brackets
12. Brake system
13. A body
14. An electric equipment
   14.1. A technical characteristics
   14.2. Detection of not closed chain
   14.3. The generator
   14.4. A starter
   14.5. Replacement of switches
   14.6. Other electric devices
   14.7. Bulbs of external illumination
   14.8. Bulbs of internal illumination
   14.9. External lighting devices
   14.10. Adjustment of light of headlights
   14.11. A combination of devices
   14.12. Elements of a combination of devices
   14.13. Hours
   14.14. Screen wiper levers
   14.15. The screen wiper and draught engine
   14.16. The engine of a screen wiper of a back door
   14.17. Washers
   14.18. A radio receiver
   14.19. Loudspeakers
   14.20. The aerial
   14.21. Anticreeping system
   14.22. A safety pillow
   14.23. Elements of a pillow of safety
   14.24. Heating and ventilation system
    14.25. Electroschemes and diagrammes


14.18. A radio receiver

RADIO RECEIVER WITH DIN CLAMPS

Removal

PERFORMANCE ORDER
1. To disconnect a negative wire from the accumulator.
2. To remove plastic заглушки from two parties of a radio receiver.
3. For radio receiver removal it is required two special U-shaped tools. To insert two special U-shaped tools on the right and at the left into apertures of the forward panel of a radio receiver.
4. Slightly to wring out the special tool outside at the expense of what brackets fastenings nestle inside.
5. In this position to extend a radio receiver uniform effort. At вытягивании not to warp a radio receiver.
6. To mark and disconnect sockets and the aerial tip.
7. To remove strippers for what to compress fastenings by a small screw-driver.
8. To remove a radio receiver.

Installation

Installation is made in sequence, return to removal.

RADIO RECEIVER WITH "PEUGEOT" CLAMPS

Removal

PERFORMANCE ORDER
1. To disconnect a negative wire from the accumulator.
2. To open a cover closing a radio receiver.
3. To remove a furnish plate over a radio receiver for access to two apertures in which tools for radio receiver removal are established.
4. For radio receiver extraction it is necessary to use the special tool or two cores with flutes on the end which incorporate with bracket fastenings.
5. To insert the special tool (it is specified by an arrow) or two cores with flutes on the end in apertures in the top part of a radio receiver before their connection with bracket fastenings and to release brackets radio receiver fastenings.
6. Using tools, to extend a radio receiver uniform effort. At вытягивании not to warp a radio receiver.

Installation

Installation is made in sequence, return to removal.