Peugeot405
1. The maintenance instruction
2. Maintenance service
3. Engines
4. Fuel system
5. Systems of greasing, cooling
6. Release system
7. Coupling
8. Transmissions
9. Power shafts
10. A steering
11. Suspension brackets
12. Brake system
13. A body
14. An electric equipment
   14.1. A technical characteristics
   14.2. Detection of not closed chain
   14.3. The generator
   14.4. A starter
   14.5. Replacement of switches
   14.6. Other electric devices
   14.7. Bulbs of external illumination
   14.8. Bulbs of internal illumination
   14.9. External lighting devices
   14.10. Adjustment of light of headlights
   14.11. A combination of devices
   14.12. Elements of a combination of devices
   14.13. Hours
   14.14. Screen wiper levers
   14.15. The screen wiper and draught engine
   14.16. The engine of a screen wiper of a back door
   14.17. Washers
   14.18. A radio receiver
   14.19. Loudspeakers
   14.20. The aerial
   14.21. Anticreeping system
   14.22. A safety pillow
   14.23. Elements of a pillow of safety
   14.24. Heating and ventilation system
    14.25. Electroschemes and diagrammes


14.13. Hours

MODELS TILL 1992

Removal

PERFORMANCE ORDER
1. To disconnect a negative wire from the accumulator.
2. To remove three locking plates located under nozzles of system of ventilation and closing screws of fastening of a guard of a combination of devices.
3. To unscrew screws and to lift a guard of a combination of devices.
4. In a back part of hours to release brackets fastenings and to take hours from the panel of devices.
5. To disconnect an electric socket and to remove hours.

Installation

Installation is made in sequence, return to removal.

MODELS SINCE 1993

Removal

PERFORMANCE ORDER
1. To disconnect a negative wire from the accumulator.
2. To remove the central console.
3. To unscrew two screws located at the bottom of a nest of an ashtray.
4. To remove a radio receiver.
5. To unscrew two screws of fastening from the top part of a frame of a radio receiver.
6. By means of a thin screw-driver to remove a decorative plate from the top corner of a frame of the central snuffled systems of ventilation and to unscrew opened screw.
7. To unscrew four screws of fastening the overlays located under the control panel heating and ventilation. Two screws are accessible from a forward part and two of the bottom part.
8. For access to the screw of fastening of the panel of devices by means of a thin screw-driver to remove the switches located under the central nozzles of system of ventilation and heating.
9. To unscrew the screw located under the switch.
10. To extend the panel with ventilation nozzles forward, to disconnect electroconducting from hours and to remove the panel with ventilation nozzles.
11. To unscrew two screws of fastening and to remove hours from the panel.

Installation

Installation is made in sequence, return to removal.