Peugeot405
1. The maintenance instruction
2. Maintenance service
3. Engines
4. Fuel system
5. Systems of greasing, cooling
6. Release system
7. Coupling
8. Transmissions
9. Power shafts
10. A steering
11. Suspension brackets
12. Brake system
13. A body
14. An electric equipment
   14.1. A technical characteristics
   14.2. Detection of not closed chain
   14.3. The generator
   14.4. A starter
   14.5. Replacement of switches
   14.6. Other electric devices
   14.7. Bulbs of external illumination
   14.8. Bulbs of internal illumination
   14.9. External lighting devices
   14.10. Adjustment of light of headlights
   14.11. A combination of devices
   14.12. Elements of a combination of devices
   14.13. Hours
   14.14. Screen wiper levers
   14.15. The screen wiper and draught engine
   14.16. The engine of a screen wiper of a back door
   14.17. Washers
   14.18. A radio receiver
   14.19. Loudspeakers
   14.20. The aerial
   14.21. Anticreeping system
   14.22. A safety pillow
   14.23. Elements of a pillow of safety
   14.24. Heating and ventilation system
    14.25. Electroschemes and diagrammes


14.20. The aerial

THE AERIAL ESTABLISHED ON THE ROOF

The aerial can be simply unscrewed from the basis. For aerial removal in the complete set it is necessary to execute following actions.

PERFORMANCE ORDER
1. To disconnect a negative wire from the accumulator.
2. To remove sun-protection peaks from the top console.
3. To remove the switch of a lamp of illumination from the panel for access to two screws. To disconnect a socket and to remove the switch of a lamp of illumination.
4. To remove a plafond of a lamp of illumination from the panel for access to the screw. To disconnect a socket and to remove an illumination lamp.
5. By means of the lever to remove locking plate from the panel, and also to remove the switch of the hatch from the panel.
6. To unscrew two screws of fastening of the panel, then to lower the panel from a ceiling.
7. By means of the lever to remove an insulator (it is specified by an arrow) from the aerial basis.
8. To unscrew a fastening nut, to disconnect an antenna wire and to remove the aerial from a roof.
9. Installation is made in sequence, return to removal.

THE AERIAL ESTABLISHED ON THE BACK WING (MODEL THE SEDAN)

PERFORMANCE ORDER
1. Completely to move the aerial.
2. Working in a luggage space, to remove furnish on the left side of a luggage carrier.
3. To disconnect antenna () and earthing () wires from the aerial basis. On models with an electric drive of the aerial to disconnect an electric socket from an aerial drive.
4. To unscrew the bottom bolt of fastening of the aerial.
5. In the top part of the aerial to unscrew a round nut, крепящую the aerial to the top part of a back wing.
6. To remove a sealing cap.
7. To take the aerial in a luggage space.
8. Installation is made in sequence, return to removal.

THE AERIAL ESTABLISHED ON THE BACK WING (MODEL КОМБИ)

The aerial acts in film as well as on cars the Sedan (see above), but the top end of the aerial is fixed by condensing ring instead of a round nut.

PERFORMANCE ORDER
1. To disconnect an electric socket of a drive of the aerial.
2. To unscrew a bolt of fastening of the aerial.
3. At aerial extraction simply to pass the aerial downwards through condensing ring.