Peugeot405
1. The maintenance instruction
2. Maintenance service
3. Engines
4. Fuel system
5. Systems of greasing, cooling
6. Release system
7. Coupling
8. Transmissions
9. Power shafts
10. A steering
11. Suspension brackets
12. Brake system
13. A body
14. An electric equipment
   14.1. A technical characteristics
   14.2. Detection of not closed chain
   14.3. The generator
   14.4. A starter
   14.5. Replacement of switches
   14.6. Other electric devices
   14.7. Bulbs of external illumination
   14.8. Bulbs of internal illumination
   14.9. External lighting devices
   14.10. Adjustment of light of headlights
   14.11. A combination of devices
   14.12. Elements of a combination of devices
   14.13. Hours
   14.14. Screen wiper levers
   14.15. The screen wiper and draught engine
   14.16. The engine of a screen wiper of a back door
   14.17. Washers
   14.18. A radio receiver
   14.19. Loudspeakers
   14.20. The aerial
   14.21. Anticreeping system
   14.22. A safety pillow
   14.23. Elements of a pillow of safety
   14.24. Heating and ventilation system
    14.25. Electroschemes and diagrammes


14.15. The screen wiper and draught engine
THE GENERAL DATA

Knot of brushes of a windscreen

1 – the holder with шарнирным the mechanism,
2 – the engine,
3 – a crank,
4 – connectors,
5 – an axis of a screen wiper,
6 – щеткодержатели,
7 – a brush

Installation of knot of a drive of a screen wiper

1 – the engine,

2 – a socket,

3 – an element of fastening of the mechanism

The screen wiper and draught engine is located in a back part of a motor compartment.

Removal

PERFORMANCE ORDER
1. To disconnect a negative wire from the accumulator.
2. To remove a lattice located before a windscreen.
3. At presence to unscrew bolts and to remove a protective cover from the engine.
4. To remove from the screen wiper engine an electric socket.
5. On models where there is not enough place for extraction of draughts of a screen wiper between the main brake cylinder and a partition to move the main brake cylinder aside as follows.
6. To unscrew nuts of fastening of the main brake cylinder to the vacuum amplifier, then to lift the main brake cylinder from racks and to move it back, without disconnecting brake tubes.
7. On models with the block of electronic control located in a back corner of a motor compartment which closes a bolt of draught of a screen wiper, the block should be removed as follows.
8. To lift a block cover, then to disconnect blocks of management and to remove the block.
9. To unscrew elements of fastening of a plate of the holder of the mechanism of a screen wiper.
10. To unscrew a bolt (it is specified by an arrow) fastenings of the engine of a screen wiper.
11. To unscrew a bolt (it is specified by an arrow) screen wiper fastenings.
12. To take a screen wiper from the car.
13. If necessary to unscrew a nut () a drive of draughts of a screen wiper and three bolts () fastenings of the engine of a screen wiper to a plate of the holder of the mechanism of a screen wiper and to remove the engine.

Installation

Installation is made in sequence, return to removal.