Peugeot405
1. The maintenance instruction
2. Maintenance service
3. Engines
    3.1. Petrol engines
    3.2. Diesel engines
    3.3. The petrol engine 1,4 дм3
    3.4. Ignition system
       3.4.1. Contactless system of ignition
         3.4.1.1. The ignition coil
         3.4.1.2. The Module-amplifier of system of ignition
         3.4.1.3. Removal and installation of the distributor of ignition
         3.4.1.4. Dismantling and distributor Ducellier assemblage
         3.4.1.5. Dismantling and distributor Bosch assemblage
         3.4.1.6. Installation of a corner of an advancing of ignition
         3.4.1.7. Check of a centrifugal regulator in the car
         3.4.1.8. Check of a vacuum regulator in the car
       3.4.2. Compound system of ignition (ignition / fuel system)
       3.4.3. Direct system of ignition
4. Fuel system
5. Systems of greasing, cooling
6. Release system
7. Coupling
8. Transmissions
9. Power shafts
10. A steering
11. Suspension brackets
12. Brake system
13. A body
14. An electric equipment





3.4.1.7. Check of a centrifugal regulator in the car
PERFORMANCE ORDER
1. To check up distributor installation (an initial corner of an advancing of ignition).
2. To disconnect the pipeline of a vacuum regulator.
3. To connect a stroboscope to a wire of ignition of the cylinder 1, and also a tachometre.
4. To use a point "0" on an adjusting plate as a reference point. To check up an advancing corner in degrees according to the characteristic.
5. If the measured values do not correspond necessary it is necessary to check up the distributor at the stand.