Peugeot405
1. The maintenance instruction
2. Maintenance service
3. Engines
    3.1. Petrol engines
    3.2. Diesel engines
    3.3. The petrol engine 1,4 дм3
    3.4. Ignition system
       3.4.1. Contactless system of ignition
         3.4.1.1. The ignition coil
         3.4.1.2. The Module-amplifier of system of ignition
         3.4.1.3. Removal and installation of the distributor of ignition
         3.4.1.4. Dismantling and distributor Ducellier assemblage
         3.4.1.5. Dismantling and distributor Bosch assemblage
         3.4.1.6. Installation of a corner of an advancing of ignition
         3.4.1.7. Check of a centrifugal regulator in the car
         3.4.1.8. Check of a vacuum regulator in the car
       3.4.2. Compound system of ignition (ignition / fuel system)
       3.4.3. Direct system of ignition
4. Fuel system
5. Systems of greasing, cooling
6. Release system
7. Coupling
8. Transmissions
9. Power shafts
10. A steering
11. Suspension brackets
12. Brake system
13. A body
14. An electric equipment


3.4.1.6. Installation of a corner of an advancing of ignition
THE GENERAL DATA

For check of installation of a corner of an advancing of ignition it is necessary to use a stroboscope.

PERFORMANCE ORDER
1. To remove заглушку (drawing at the left), located on картере couplings, that adjusting labels were visible (are specified by an arrow in drawing on the right) on a flywheel and a plate screwed to картеру.
2. To start the engine, to warm up to working temperature, then to switch off.
3. To remove a vacuum hose from the distributor of ignition and to close its stopper.
4. To connect a stroboscope according to the instruction.
5. To start the engine in a mode of idling and to direct a stroboscope on labels. The adjusting label of a flywheel should be combined with a label on a plate on which degrees of displacement of installation of a corner of ignition from the top dead point (ВМТ) are specified.
6. In need of adjustment to weaken nuts of fastening of the distributor of ignition and slowly to turn it before combination of corresponding labels.
7. After combination of labels to tighten nuts of fastening of the distributor and repeatedly to check up a corner of an advancing of ignition.
8. To increase frequency of rotation of the engine and to be convinced that labels start to move aside большего increases in a corner of an advancing of ignition. It shows that the centrifugal regulator of a corner of an advancing of ignition works.
9. To establish a vacuum hose into place and to make check of a corner of an advancing of ignition on the increased turns of the engine. Thus labels should move in even большей degrees. It shows that the vacuum regulator of a corner of an advancing of ignition works.