Peugeot405
1. The maintenance instruction
2. Maintenance service
3. Engines
    3.1. Petrol engines
    3.2. Diesel engines
    3.3. The petrol engine 1,4 дм3
    3.4. Ignition system
       3.4.1. Contactless system of ignition
         3.4.1.1. The ignition coil
         3.4.1.2. The Module-amplifier of system of ignition
         3.4.1.3. Removal and installation of the distributor of ignition
         3.4.1.4. Dismantling and distributor Ducellier assemblage
         3.4.1.5. Dismantling and distributor Bosch assemblage
         3.4.1.6. Installation of a corner of an advancing of ignition
         3.4.1.7. Check of a centrifugal regulator in the car
         3.4.1.8. Check of a vacuum regulator in the car
       3.4.2. Compound system of ignition (ignition / fuel system)
       3.4.3. Direct system of ignition
4. Fuel system
5. Systems of greasing, cooling
6. Release system
7. Coupling
8. Transmissions
9. Power shafts
10. A steering
11. Suspension brackets
12. Brake system
13. A body
14. An electric equipment


3.4.1.3. Removal and installation of the distributor of ignition

Removal

PERFORMANCE ORDER
1. To improve access to the ignition distributor, preliminary to remove the ignition coil.
2. To remove from the ignition distributor a protective water-proof cover.
3. To unscrew screws of fastening of the distributor of ignition.
4. To uncover the ignition distributor.
5. If necessary to remove high-voltage wires from a cover and spark plugs.
6. To disconnect the pipeline of a vacuum regulator.
7. To disconnect a socket from the electronic module.
8. To note mutual position of the case of the distributor and a head of the block of cylinders (arrows specify labels of installation of the moment of ignition).
9. To displace grooves on distributive to a shaft for a lead of a drive of the distributor of ignition.
10. To remove elements of fastening of the distributor and to take the distributor.

Installation

PERFORMANCE ORDER
1. To check up and, if necessary, to replace a round sealing ring on the landing end of the distributor.
2. To establish the distributor, turning a rotor so that correctly to arrange a drive lead (only one position).
3. To screw in bolts of fastening of the distributor.
4. To establish a distributor rotor.
5. To establish and fix a distributor cover.
6. To connect wires.
7. To adjust a corner of an advancing of ignition (subsection 3.4.1.6 see).