Peugeot405
1. The maintenance instruction
2. Maintenance service
3. Engines
    3.1. Petrol engines
    3.2. Diesel engines
    3.3. The petrol engine 1,4 дм3
    3.4. Ignition system
       3.4.1. Contactless system of ignition
         3.4.1.1. The ignition coil
         3.4.1.2. The Module-amplifier of system of ignition
         3.4.1.3. Removal and installation of the distributor of ignition
         3.4.1.4. Dismantling and distributor Ducellier assemblage
         3.4.1.5. Dismantling and distributor Bosch assemblage
         3.4.1.6. Installation of a corner of an advancing of ignition
         3.4.1.7. Check of a centrifugal regulator in the car
         3.4.1.8. Check of a vacuum regulator in the car
       3.4.2. Compound system of ignition (ignition / fuel system)
       3.4.3. Direct system of ignition
4. Fuel system
5. Systems of greasing, cooling
6. Release system
7. Coupling
8. Transmissions
9. Power shafts
10. A steering
11. Suspension brackets
12. Brake system
13. A body
14. An electric equipment


3.4.1.4. Dismantling and distributor Ducellier assemblage
THE GENERAL DATA

Distributor Ducellier
1 – a cover of the distributor,
2 – a rotor of the distributor,
3 – противопылевой a casing,
4 – the case of the distributor,
 5 – the bottom holder,
6 – the generator of impulses,
8 – a centrifugal regulator,
9 – a vacuum regulator

Dismantling

PERFORMANCE ORDER
1. To remove the distributor.
2. To take out a rotor of the distributor and противопылевой a casing.
3. To unscrew three bolts of fastening of the top part of the distributor.
4. To incline and take out the top part.
5. To take knot "wire-socket".
6. To remove a plastic ring, the generator of impulses and a vacuum regulator (1 bolt).

Assemblage

PERFORMANCE ORDER
1. To establish the generator of impulses and a vacuum regulator, inserting its axis of gearing into an aperture of a disk with ledges (a hyphen on a disk opposite to an aperture).
2. To establish a plastic ring.
3. To establish the top part of the distributor: to tighten bolts of fastening of a vacuum regulator and three bolts of the top part.
4. To establish knot "wire-socket".
5. To establish a rotor and противопылевой a casing.
6. To establish the distributor.