Peugeot405
1. The maintenance instruction
2. Maintenance service
3. Engines
    3.1. Petrol engines
      3.1.1. A technical characteristics
       3.1.2. Engine repair
          3.1.2.1. The repair which is not demanding removal of the engine
          3.1.2.2. Engine removal
         3.1.2.3. Engine installation
         3.1.2.4. Engine dismantling
          3.1.2.5. Engine assemblage
            3.1.2.5.1. Clearing and check of details
            3.1.2.5.2. Шатунные and radical loose leaves
            3.1.2.5.3. Definition of the size of loose leaves
            3.1.2.5.4. Check of a working backlash in bearings of a cranked shaft
            3.1.2.5.5. A cranked shaft
            3.1.2.5.6. Knot a rod-piston
            3.1.2.5.7. Assemblage of knot a rod-finger-piston
         3.1.2.6. Start of the engine after major repairs
    3.2. Diesel engines
    3.3. The petrol engine 1,4 дм3
    3.4. Ignition system
4. Fuel system
5. Systems of greasing, cooling
6. Release system
7. Coupling
8. Transmissions
9. Power shafts
10. A steering
11. Suspension brackets
12. Brake system
13. A body
14. An electric equipment


3.1.2.5. Engine assemblage
THE GENERAL DATA

The prevention

In some engines of the early period of release in a head of the block of cylinders bolts of old type, i.e. with шестигранной a head are used. In case of assemblage of knot a sleeve of the cylinder-piston of new type (cut on sleeves of cylinders) in the engine of the early period of release (without cut on sleeves of cylinders) it is necessary to replace following details necessarily: bolts of a head of the block of cylinders (Torx N55), washers under these bolts and the modified lining of a head. It is necessary to observe also a method of a tightening of a head of the block of the cylinders, specific to bolts Torx.