1. The maintenance instruction
2. Maintenance service
3. Engines
    3.1. Petrol engines
      3.1.1. A technical characteristics
       3.1.2. Engine repair
 The repair which is not demanding removal of the engine
 Engine removal Engine installation Engine dismantling
 Engine assemblage Start of the engine after major repairs
    3.2. Diesel engines
    3.3. The petrol engine 1,4 дм3
    3.4. Ignition system
4. Fuel system
5. Systems of greasing, cooling
6. Release system
7. Coupling
8. Transmissions
9. Power shafts
10. A steering
11. Suspension brackets
12. Brake system
13. A body
14. An electric equipment Start of the engine after major repairs
1. After engine installation in the car to check up level of oil and cooling liquid.
2. To unscrew spark plugs and to disconnect ignition system.
3. To turn the engine a starter while the lamp of emergency pressure of oil will not go out.
4. To screw in spark plugs and to connect ignition system.
5. To start the engine and to check up tightness of all systems. Дымление the engine is the normal phenomenon as there is a burning out of the oil which have got on a detail at assemblage of the engine.
6. On engines with 16 valves knock of hydraulic pushers of valves before full filling with their oil will be audible.
7. To check up installation of a corner of an advancing of ignition and idling turns.
8. After several minutes of work of the engine repeatedly to check up levels of oil and cooling liquid.
9. If on the engine new pistons, rings or loose leaves of a cranked shaft have been established, with the engine it is necessary to address as with new and to make обкатку, then to replace engine oil and the filter.