Peugeot405
1. The maintenance instruction
2. Maintenance service
3. Engines
4. Fuel system
5. Systems of greasing, cooling
6. Release system
7. Coupling
8. Transmissions
    8.1. A mechanical transmission
    8.2. An automatic transmission
      8.2.1. A technical characteristics
      8.2.2. The drive description
      8.2.3. Removal and transmission installation
      8.2.4. Adjustment of management by a gear change
      8.2.5. A cable of a choice of transfers
      8.2.6. The selector lever
      8.2.7. A cable of compulsory inclusion of a hill-climbing gear
      8.2.8. Adjustment of a tape of a brake
      8.2.9. Removal and installation of the operating servomotor
      8.2.10. Replacement of a sealing ring of an axis of the selector
      8.2.11. The transmission heat exchanger
9. Power shafts
10. A steering
11. Suspension brackets
12. Brake system
13. A body
14. An electric equipment


8.2.9. Removal and installation of the operating servomotor
THE GENERAL DATA

Arrangement of bolts of fastening of the operating servomotor

Fastening bolts are specified by arrows.

Removal

PERFORMANCE ORDER
1. To merge oil from an automatic transmission.
2. To remove the oil pallet.
3. To hold a pedal of an accelerator pressed by means of the special adaptation for pedal pressing (the adaptation 0204).
4. To unscrew 10 bolts of fastening of the operating servomotor and to remove it.

Installation of the operating servomotor


Installation

PERFORMANCE ORDER
1. In the car to establish the gear change lever in position "1".
2. On an automatic transmission:
      – To check up, whether sectors (1) and (2) so that surfaces () are established and () were at one level;
      – To check up, whether occupy correct position a shaft (3) and a cam (4) (by pressing of a pedal in the car).
3. On the operating servomotor:
      – To press ползун (5) and the piston (6) in a nest.
4. To establish the operating servomotor on an automatic transmission and to check up, whether (7) the ledge has entered into a clip (8) ползуна (5) and whether (9) the end of an axis has entered into an aperture (10).
5. To screw in bolts of fastening of the operating servomotor (shorter – "With", longer – "D") and to tighten their corresponding moments.
6. To establish the oil pallet.
7. In the car to take the special adaptation for pressing of a pedal of an accelerator.
8. To fill in oil in an automatic transmission to necessary level.