Peugeot405
1. The maintenance instruction
2. Maintenance service
3. Engines
4. Fuel system
5. Systems of greasing, cooling
6. Release system
7. Coupling
8. Transmissions
    8.1. A mechanical transmission
    8.2. An automatic transmission
      8.2.1. A technical characteristics
      8.2.2. The drive description
      8.2.3. Removal and transmission installation
      8.2.4. Adjustment of management by a gear change
      8.2.5. A cable of a choice of transfers
      8.2.6. The selector lever
      8.2.7. A cable of compulsory inclusion of a hill-climbing gear
      8.2.8. Adjustment of a tape of a brake
      8.2.9. Removal and installation of the operating servomotor
      8.2.10. Replacement of a sealing ring of an axis of the selector
      8.2.11. The transmission heat exchanger
9. Power shafts
10. A steering
11. Suspension brackets
12. Brake system
13. A body
14. An electric equipment





8.2.11. The transmission heat exchanger
THE GENERAL DATA

The transmission heat exchanger

1 – a hose of a cooling liquid,

2 – a hose of a cooling liquid,

3 – a bolt of fastening of the heat exchanger,

4 – the heat exchanger

Removal

PERFORMANCE ORDER
1. The heat exchanger is established on the top part картера transmissions. For access to the heat exchanger to remove tubes of giving of air in the engine.
2. Using a clip, to press both hoses of giving of a cooling liquid to the heat exchanger, to reduce loss of a cooling liquid.
3. To weaken collars, and to disconnect both hoses of a cooling liquid from the heat exchanger.
4. To unscrew the central bolt of fastening of the heat exchanger, and to remove the heat exchanger from a transmission. To remove from the heat exchanger two sealing rings.

Sealing rings of the heat exchanger

1 – an internal sealing ring,

2 – an external sealing ring,

3 – a sealing ring of the central bolt

Installation

PERFORMANCE ORDER
To grease pure трансмиссионной with a liquid new sealing rings and to establish them on the basis of the heat exchanger. The further installation is made in sequence of return to removal then it is necessary to add a cooling liquid in cooling system.