8.2.5. A cable of a choice of transfers//Pezho 405 1987-1997 / pkkr.ru

Peugeot405
1. The maintenance instruction
2. Maintenance service
3. Engines
4. Fuel system
5. Systems of greasing, cooling
6. Release system
7. Coupling
8. Transmissions
    8.1. A mechanical transmission
    8.2. An automatic transmission
      8.2.1. A technical characteristics
      8.2.2. The drive description
      8.2.3. Removal and transmission installation
      8.2.4. Adjustment of management by a gear change
      8.2.5. A cable of a choice of transfers
      8.2.6. The selector lever
      8.2.7. A cable of compulsory inclusion of a hill-climbing gear
      8.2.8. Adjustment of a tape of a brake
      8.2.9. Removal and installation of the operating servomotor
      8.2.10. Replacement of a sealing ring of an axis of the selector
      8.2.11. The transmission heat exchanger
9. Power shafts
10. A steering
11. Suspension brackets
12. Brake system
13. A body
14. An electric equipment

8.2.5. A cable of a choice of transfers

THE GENERAL DATA

Selector cable

Removal

PERFORMANCE ORDER

1. To lift a forward part of the car and to fix on supports. To establish the selector lever in position "P".

2. For access improvement to remove the accumulator, a support of the accumulator and an installation suspension bracket.

3. To remove the central console.

4. To disconnect a cable from the lever of the selector and an installation suspension bracket.

5. On a transmission to unscrew two screws of fastening of a cover of a cable to an arm and to remove the spherical hinge of a cable from the selector lever. Not to move the selector lever at the removed cable.

6. To disconnect a cable of the selector from скоб fastenings.

7. To remove a rubber condensing ring from a partition and to take a selector cable in a motor compartment.

Adjustment of a drive of the selector

1 – a tip of a cable,

2 – the spherical hinge of the lever of the selector,

3 – counternuts of adjustment of a cover of a cable

Installation

Installation is made in sequence, return to removal then it is necessary to make adjustment of a cable of the selector.