Peugeot405
1. The maintenance instruction
2. Maintenance service
3. Engines
4. Fuel system
5. Systems of greasing, cooling
6. Release system
7. Coupling
8. Transmissions
    8.1. A mechanical transmission
    8.2. An automatic transmission
      8.2.1. A technical characteristics
      8.2.2. The drive description
      8.2.3. Removal and transmission installation
      8.2.4. Adjustment of management by a gear change
      8.2.5. A cable of a choice of transfers
      8.2.6. The selector lever
      8.2.7. A cable of compulsory inclusion of a hill-climbing gear
      8.2.8. Adjustment of a tape of a brake
      8.2.9. Removal and installation of the operating servomotor
      8.2.10. Replacement of a sealing ring of an axis of the selector
      8.2.11. The transmission heat exchanger
9. Power shafts
10. A steering
11. Suspension brackets
12. Brake system
13. A body
14. An electric equipment


8.2.4. Adjustment of management by a gear change
THE GENERAL DATA

Adjustment of management by a gear change

1 – the spherical hinge,

2 – a control lever a gear change

PERFORMANCE ORDER
1. To remove knot of the air filter.
2. To separate the spherical hinge (1) managements of a gear change (2) from the selector lever.
3. To establish the selector lever against the stop forward (position "Р").
4. In salon to establish the gear change lever in position "Р".
5. It is easy to pull a cable of management of a gear change and to change (screwing in or unscrewing) position of the spherical hinge so that it has settled down opposite to the spherical hinge of the lever of the selector.
6. To connect a cable of management of a gear change to the selector lever.
7. In salon some times to move the lever of a gear change from an emphasis against the stop, and then to check up, whether the car in position "Р" is fixed.