Peugeot405
1. The maintenance instruction
2. Maintenance service
3. Engines
4. Fuel system
5. Systems of greasing, cooling
6. Release system
7. Coupling
8. Transmissions
9. Power shafts
10. A steering
11. Suspension brackets
    11.1. A forward suspension bracket
    11.2. A back suspension bracket
      11.2.1. A technical characteristics
      11.2.2. Shock-absorber replacement
      11.2.3. Replacement torsionов
      11.2.4. The stabilizer
      11.2.5. The suspension bracket lever
      11.2.6. Removal and installation of a back suspension bracket
      11.2.7. Adjustment of height of a suspension bracket of a body
      11.2.8. Naves of back wheels
      11.2.9. Features of a back suspension bracket of cars 4 х 4
      11.2.10. Tank replacement
      11.2.11. Removal and installation of the lever of a suspension bracket
      11.2.12. Removal and installation of the cylinder of a suspension bracket
      11.2.13. Removal of air from a hydraulic contour
      11.2.14. Removal and pump installation
      11.2.15. Removal and nave installation
12. Brake system
13. A body
14. An electric equipment


11.2.8. Naves of back wheels Removal

PERFORMANCE ORDER
1. To lift the car and to remove a wheel on the corresponding party.
2. To remove a brake drum or a brake disk.
3. At presence to remove gauge ABS.
4. By means of the lever to remove a protective cap of the central part of a nave of a back wheel.
5. Using a hammer and a punch, to unbend fixing fillet on a nut of fastening of a nave of a back wheel.
6. To unscrew a nut of a nave and to remove an axial ring.
7. By means of a stripper to remove from a pin a nave, the internal bearing and a sealing ring.
8. To remove the internal bearing (drawing at the left) and a sealing ring (drawing on the right).
9. To remove a basic cup.
10. The nave is not under repair.

The fillet of a nut pressed into a groove of a pin


Installation

PERFORMANCE ORDER
1. To grease a pin with the means facilitating installation of elements.
2. Using the adaptation 8.0530 D, to establish a new basic cup for a sealing ring.
3. To place on a pin the internal case of a nave. To press it by means of a nut (new).
4. To establish one, and then two remote linings (0530) behind a nut for case pushing through on a pin.
5. To place a nave on a pin (drawing at the left) and to press it by means of corresponding send (drawing on the right).
6. When it will be possible, to establish an axial ring and to screw a nave nut.
7. To tighten a nut the necessary moment and to fix it from unscrewing.
8. To establish a cap of a nave, a brake drum and a wheel.
9. To lower the car.