Peugeot405
1. The maintenance instruction
2. Maintenance service
3. Engines
4. Fuel system
5. Systems of greasing, cooling
6. Release system
7. Coupling
8. Transmissions
9. Power shafts
10. A steering
11. Suspension brackets
    11.1. A forward suspension bracket
    11.2. A back suspension bracket
      11.2.1. A technical characteristics
      11.2.2. Shock-absorber replacement
      11.2.3. Replacement torsionов
      11.2.4. The stabilizer
      11.2.5. The suspension bracket lever
      11.2.6. Removal and installation of a back suspension bracket
      11.2.7. Adjustment of height of a suspension bracket of a body
      11.2.8. Naves of back wheels
      11.2.9. Features of a back suspension bracket of cars 4 х 4
      11.2.10. Tank replacement
      11.2.11. Removal and installation of the lever of a suspension bracket
      11.2.12. Removal and installation of the cylinder of a suspension bracket
      11.2.13. Removal of air from a hydraulic contour
      11.2.14. Removal and pump installation
      11.2.15. Removal and nave installation
12. Brake system
13. A body
14. An electric equipment





11.2.4. The stabilizer Removal

PERFORMANCE ORDER
1. To establish the car on supports and to remove wheels.
2. To unscrew bolts of fastening and to remove linings.
3. To weaken bolts of a flange of the stabilizer on the lever, to unscrew the right bolt (depending on the decision).
4. To establish on the stabilizer a tip 0908 Q (a shaft improved with carving М8х125), and on a tip – an inertial stripper (8.0316).
5. To take the stabilizer.
6. To clear Slots on the stabilizer and in the lever.

Installation

PERFORMANCE ORDER
1. To check up conformity to requirements and cleanliness of elements.
2. It is easy to grease Slots with greasing Esso Norva 275.
3. To establish on the stabilizer a tip 0908 Q.
4. To establish on a tip a stripper.
5. To establish the stabilizer in levers in such position in which it enters freely.
6. To centre the stabilizer in fastening flanges (in case of need to use a stripper).
7. To establish basic linings.
8. To screw up a bolt of fastening of a basic lining.
9. To tighten flange bolts the corresponding moment.
10. To establish wheels.
11. To establish the car on wheels.