Peugeot405
1. The maintenance instruction
2. Maintenance service
3. Engines
4. Fuel system
5. Systems of greasing, cooling
6. Release system
7. Coupling
8. Transmissions
9. Power shafts
10. A steering
   10.1. A technical characteristics
   10.2. A steering wheel
   10.3. A steering column
   10.4. The ignition lock
   10.5. Steering transfer
   10.6. Replacement of protective covers of the steering mechanism
   10.7. Removal of air from system of a steering with the amplifier
   10.8. The pump of the amplifier of a steering
   10.9. Check of level of oil in system of a steering with the hydraulic booster
   10.10. A tip of steering draught
   10.11. Steering draught
   10.12. Corners of installation of wheels
   10.13. Changes in steering system
11. Suspension brackets
12. Brake system
13. A body
14. An electric equipment


10.4. The ignition lock Removal

PERFORMANCE ORDER
1. To remove a wire of weight from the accumulator.
2. To remove casings of a steering column.
3. Under a steering column to disconnect electric sockets from the lock of ignition and to release wires from скоб fastenings.
4. To insert the ignition key into the lock and to turn before combination with a small arrow on a lock frame.
5. To unscrew the screw of fastening of the lock of ignition.
6. A small screw-driver to press keeping ledge, and simultaneously to pull for a key the lock of ignition from the case.
7. To take the ignition lock, passing electroconducting through a pipe of a steering column.
8. For branch of contact group from the lock to execute following actions.
9. To unscrew two screws (are specified by arrows) from a back part of the lock of ignition.
10. To remove a back part of the lock of ignition.
11. To take contact group of the lock of ignition.

Installation

PERFORMANCE ORDER
1. At installation on a former place of the lock of ignition to check up that the ignition key is taken from the lock and, as far as possible, to turn the screen wiper switch counter-clockwise. To check up that ledges on a screen wiper were combined with safety locks in the ignition lock.
2. The further installation is made in sequence of return to removal.