Peugeot405
1. The maintenance instruction
2. Maintenance service
3. Engines
4. Fuel system
5. Systems of greasing, cooling
6. Release system
7. Coupling
8. Transmissions
9. Power shafts
10. A steering
   10.1. A technical characteristics
   10.2. A steering wheel
   10.3. A steering column
   10.4. The ignition lock
   10.5. Steering transfer
   10.6. Replacement of protective covers of the steering mechanism
   10.7. Removal of air from system of a steering with the amplifier
   10.8. The pump of the amplifier of a steering
   10.9. Check of level of oil in system of a steering with the hydraulic booster
   10.10. A tip of steering draught
   10.11. Steering draught
   10.12. Corners of installation of wheels
   10.13. Changes in steering system
11. Suspension brackets
12. Brake system
13. A body
14. An electric equipment





10.3. A steering column Removal

PERFORMANCE ORDER
1. To remove a wire of weight from the accumulator.
2. At presence to remove a safety pillow.
3. To remove a steering wheel.
4. To remove casings of a steering column.
5. To remove the ignition lock.
6. On models since 1992 to release brackets fastenings, and to lower a box with fuses downwards from the panel.
7. In a forward bottom part of salon of the car to turn on the carpet covering of a floor for access to a bolt of fastening of a steering column.
8. Under a steering column to disconnect three sockets (are specified by arrows for models since 1993) from the ignition lock. In the same way, at presence to disconnect a socket of wires from a safety pillow.
9. In a forward bottom part of salon of the car to put combination labels on intermediate to a shaft and a shaft of a steering column.
10. To unscrew tightening a bolt, securing the a shaft of a steering column to an intermediate shaft.
11. To unscrew two bottom bolts of fastening of a steering column (are specified by arrows for models since 1993).
12. To unscrew the top nuts of fastening of a steering column (are specified by arrows for models till 1992), then to take a steering column from the car.

Check

PERFORMANCE ORDER
To check up a condition of a steering column on damages and deterioration. To check up backlash a steering shaft in plugs of a steering column and a condition of universal hinges.

Installation

PERFORMANCE ORDER
1. Installation is made in sequence of return to removal.
2. On models with a safety pillow to establish a steering column into place, then to check up that the backlash between a back part of a steering wheel and column casings makes 8,0 mm. If the backlash differs from demanded, to execute following actions:
      – To weaken a coupling bolt of fastening of a shaft of a steering column to an intermediate shaft, and to move a steering shaft as required to receive a demanded backlash between a steering wheel and casings;
      – To compress a coupling bolt and to establish furnish.