Peugeot405
1. The maintenance instruction
2. Maintenance service
3. Engines
4. Fuel system
5. Systems of greasing, cooling
6. Release system
7. Coupling
8. Transmissions
9. Power shafts
10. A steering
   10.1. A technical characteristics
   10.2. A steering wheel
   10.3. A steering column
   10.4. The ignition lock
   10.5. Steering transfer
   10.6. Replacement of protective covers of the steering mechanism
   10.7. Removal of air from system of a steering with the amplifier
   10.8. The pump of the amplifier of a steering
   10.9. Check of level of oil in system of a steering with the hydraulic booster
   10.10. A tip of steering draught
   10.11. Steering draught
   10.12. Corners of installation of wheels
   10.13. Changes in steering system
11. Suspension brackets
12. Brake system
13. A body
14. An electric equipment


10.10. A tip of steering draught Removal

PERFORMANCE ORDER
1. To lift a forward part of the car and to fix on supports. To remove a corresponding forward wheel.
2. Using чертилку to note position of the spherical hinge on steering draught.
3. To fix steering draught and to unscrew a counternut of the spherical hinge (it is specified by an arrow) on a turn quarter. Not to move a counternut from this position as it will serve as a reference point at installation of the new spherical hinge.
4. To unscrew a nut of fastening of the spherical hinge to a rotary fist and to remove the spherical hinge from it.
5. To unscrew the spherical hinge from steering draught, having counted exact number of turns of the spherical hinge.
6. To count number of full coils of a carving between the end of the spherical hinge and a counternut. If it is necessary to establish the new spherical hinge, to unscrew from the old hinge a counternut.
7. Carefully to clear the spherical hinge and its carving. If the hinge has backlash or its protective cover is damaged, it is necessary to replace it.

Installation

PERFORMANCE ORDER
1. If the new spherical hinge of steering draught is established, to screw on it a counternut on that quantity of coils which was on the old spherical hinge at removal.
2. To screw up the spherical hinge in steering draught on the same number of turns, as at removal. Thus the counternut on the hinge should be established on a quarter of a turn from steering draught.
3. To establish a pin of the spherical hinge in a rotary fist, to fix a new nut and to tighten its demanded moment.
4. To establish a wheel and to lower the car.
5. To check up and if necessary to adjust corners of installation of forward wheels. After that to tighten a counternut of the spherical hinge of steering draught.