Peugeot405
1. The maintenance instruction
2. Maintenance service
3. Engines
4. Fuel system
    4.1. Fuel system with the carburettor
    4.2. One-dot systems of injection of fuel
    4.3. Multidot systems of injection of fuel
      4.3.1. The air filter
      4.3.2. An accelerator cable
      4.3.3. Systems of injection of fuel
      4.3.4. Check and adjustment of systems of injection of fuel
      4.3.5. The case throttle заслонки
      4.3.6. Elements of system of injection Bosch L3. 1-Jetronic
      4.3.7. Elements of system of injection Bosch LU2-Jetronic
      4.3.8. Elements of system of injection Bosch Motronic
      4.3.9. Elements of system of injection Magnetti Marelli
      4.3.10. An inlet collector
      4.3.11. System of giving of air ACAV (models with 16 valves)
5. Systems of greasing, cooling
6. Release system
7. Coupling
8. Transmissions
9. Power shafts
10. A steering
11. Suspension brackets
12. Brake system
13. A body
14. An electric equipment


4.3.10. An inlet collector
THE GENERAL DATA

Hermetic application at collector installation


To check up presence of directing probes at collector installation

The directing probe is specified by an arrow.

Installation of an inlet collector


Screwing up of bolts of fastening of a collector


SYSTEM BOSCH L3. L (JETRONIC)

Removal

PERFORMANCE ORDER
1. To remove a fuel highway, without disconnecting hoses.
2. To remove a vacuum hose of the amplifier of brakes.
3. To remove the case of throttles.  
4. To remove ignition coils.  
5. To remove an additional air hose of an air inlet from a collector.
6. To unscrew a bolt from a starter suspension bracket.
7. To unscrew a bolt of support of an oil pipe.
8. To unscrew bolts of fastening of a collector and two bolts of 5 mm. For unscrewing of bolts of 5 mm the long key is required.
9. To remove a collector.

SYSTEMS BOSCH LU2-JETRONIC, MOTRONIC AND MAGNETI MAREILLI

Removal

PERFORMANCE ORDER
Procedure of removal of a collector is similar described above, considering following moments:
      – Vacuum hoses and a hose of a cooling liquid and electroconducting change depending on model. At separation of any pipes, hoses, or wires, take into consideration their site to guarantee correct installation on a former place;
      – Ignore references on заборник air and a starter suspension bracket;
      – It is necessary to replace any removed linings.