1. The maintenance instruction
2. Maintenance service
   2.1. A technical characteristics
    2.2. Periodicity of service
    2.3. Each 7 500 km
    2.4. Each 10 000 km or 6 months
      2.4.1. Engine oil and filter replacement
      2.4.2. Level check трансмиссионного oils
      2.4.3. Check and tension adjustment клинового a belt
      2.4.4. Check auxiliary driving a belt
       2.4.5. Removal, installation and tension adjustment клинового driving a belt Early models Models with manual adjustment of a tension Models with automatic adjustment of a tension
      2.4.6. The pump of the amplifier of a steering (XU9J4 with 16 valves)
    2.5. Each 20 000 km or 12 months
    2.6. Each 30 000 km or 18 months
    2.7. Each 40 000 km or 2 years
    2.8. Each 60 000 km or 3 years
3. Engines
4. Fuel system
5. Systems of greasing, cooling
6. Release system
7. Coupling
8. Transmissions
9. Power shafts
10. A steering
11. Suspension brackets
12. Brake system
13. A body
14. An electric equipment Models with automatic adjustment of a tension


1. To remove a wire of weight from the accumulator.
2. To remove from the engine a protective casing.
3. To establish its square key in a square aperture in the basis of an automatic suspension bracket of a regulator, to turn a suspension bracket counter-clockwise, to release the tension device of a belt. The suspension bracket clip in this position makes 4,0 mm.
4. To unscrew assembly bolts and to remove a roller of the mechanism of a tension and to check up a condition of pulleys and auxiliary driving a belt.

Installation and tension adjustment

1. To establish a new belt on pulleys.
2. To establish a roller of the mechanism of a tension and to tighten assembly bolts.
3. Use of a square key provides compression of an automatic regulator, then slowly allows the tension mechanism to pull a belt.
4. To establish on the engine a protective casing.
5. To connect a wire of weight of the accumulator.