Peugeot405
1. The maintenance instruction
2. Maintenance service
   2.1. A technical characteristics
    2.2. Periodicity of service
    2.3. Each 7 500 km
    2.4. Each 10 000 km or 6 months
      2.4.1. Engine oil and filter replacement
      2.4.2. Level check трансмиссионного oils
      2.4.3. Check and tension adjustment клинового a belt
      2.4.4. Check auxiliary driving a belt
       2.4.5. Removal, installation and tension adjustment клинового driving a belt
         2.4.5.1. Early models
         2.4.5.2. Models with manual adjustment of a tension
         2.4.5.3. Models with automatic adjustment of a tension
      2.4.6. The pump of the amplifier of a steering (XU9J4 with 16 valves)
    2.5. Each 20 000 km or 12 months
    2.6. Each 30 000 km or 18 months
    2.7. Each 40 000 km or 2 years
    2.8. Each 60 000 km or 3 years
3. Engines
4. Fuel system
5. Systems of greasing, cooling
6. Release system
7. Coupling
8. Transmissions
9. Power shafts
10. A steering
11. Suspension brackets
12. Brake system
13. A body
14. An electric equipment


2.4.5.2. Models with manual adjustment of a tension

Removal

PERFORMANCE ORDER
1. To remove a wire of weight from the accumulator.
2. To remove from the engine a protective casing.
3. To weaken bolts of installation (adjustment) of a suspension bracket of a pulley of the mechanism of a tension (one is located in the middle of a pulley, another – in the bottom of a suspension bracket).
4. Completely to release a bolt (it is specified by an arrow) regulations and to remove driving a belt from pulleys.

Installation and tension adjustment

PERFORMANCE ORDER
1. To establish a new belt on pulleys.
2. The correct tension driving a belt guarantees its durability. The loose belt will slip and, probably, to squeal. However the drawn belt will increase deterioration in bearings of the generator of an alternating current.
3. The belt tension should be adjusted so that by moderate pressing of a thumb of a hand the middle of a long branch of a belt the belt deflection made approximately 5,0 mm.
4. For adjustment of a tension of a belt to unscrew a regulation bolt, then to turn a cranked shaft and repeatedly to check a tension.
5. It is reliable to tighten bolts of installation of a suspension bracket of a pulley of the mechanism of a tension.
6. To establish on the engine a protective casing.
7. To connect a wire of weight of the accumulator.