Peugeot405
1. The maintenance instruction
2. Maintenance service
   2.1. A technical characteristics
    2.2. Periodicity of service
    2.3. Each 7 500 km
    2.4. Each 10 000 km or 6 months
      2.4.1. Engine oil and filter replacement
      2.4.2. Level check трансмиссионного oils
      2.4.3. Check and tension adjustment клинового a belt
      2.4.4. Check auxiliary driving a belt
       2.4.5. Removal, installation and tension adjustment клинового driving a belt
      2.4.6. The pump of the amplifier of a steering (XU9J4 with 16 valves)
    2.5. Each 20 000 km or 12 months
    2.6. Each 30 000 km or 18 months
    2.7. Each 40 000 km or 2 years
    2.8. Each 60 000 km or 3 years
3. Engines
4. Fuel system
5. Systems of greasing, cooling
6. Release system
7. Coupling
8. Transmissions
9. Power shafts
10. A steering
11. Suspension brackets
12. Brake system
13. A body
14. An electric equipment


2.4.2. Level check трансмиссионного oils
THE GENERAL DATA
The prevention

On models since 1994 of manufacturing the specified interval for this procedure – 15 000 km or 12 months.

Щуп for level measurement трансмиссионного oils

 Щуп for level measurement the engine / a transmission is located on the forward party of the engine, directly ahead of connection. Top щупа for measurement of level of bright colour (usually orange) for easy identification.

And – bottom marks,

In – the top marks

PERFORMANCE ORDER
1. To make on the car a short trip for warming up of a transmission to normal working temperature, then to park a vehicle on a horizontal platform and to check up oil level.
2. At engine work idling and the lever of the selector of an automatic transmission in position “P” (parking) to take щуп for measurement of level from трубыи to wipe all liquid from the end щупа a pure rag or a paper towel.
3. To insert pure щуп for level measurement back into a pipe against the stop, then to take once again and to define liquid level on the end щупа which should be between the top and bottom labels (hyphens).
4. If low, the demanded quantity of the specified liquid through a pipe щупа for level measurement is necessary to add level.
The prevention

Never suppose, that liquid level was above the top label.
5. After refuelling трансмиссионного oils to spend a trial trip for full distribution of oil and repeatedly to measure oil level.
6. The frequent requirement in доливке трансмиссионного oils specifies that there is a leak which is necessary for finding and eliminating.