Peugeot405
1. The maintenance instruction
2. Maintenance service
3. Engines
4. Fuel system
5. Systems of greasing, cooling
6. Release system
7. Coupling
8. Transmissions
9. Power shafts
10. A steering
11. Suspension brackets
    11.1. A forward suspension bracket
      11.1.1. A technical characteristics
      11.1.2. A rotary fist
      11.1.3. Replacement of the forward bearing of a nave
      11.1.4. A forward rack
      11.1.5. Repair of a forward rack
      11.1.6. The bottom lever of a forward suspension bracket
      11.1.7. The bottom spherical hinge of a forward suspension bracket
      11.1.8. The stabilizer of cross-section stability of a forward suspension bracket
      11.1.9. A connector of the stabilizer of cross-section stability of a forward suspension bracket
      11.1.10. The bottom frame of a forward suspension bracket
    11.2. A back suspension bracket
12. Brake system
13. A body
14. An electric equipment


11.1.3. Replacement of the forward bearing of a nave
THE GENERAL DATA
The prevention

Двухрядный the roller bearing does not demand any adjustments and has the greasing providing working capacity of the bearing on all service life of the car. At bearing installation it is necessary to use a new lock ring.

PERFORMANCE ORDER
1. To remove a rotary fist together with a nave from the car.
2. To establish a rotary fist on supports and using tubular the mandrel, established on the internal end of a flange, to squeeze out a flange from the bearing. If the internal ring of the bearing remains on a nave, to remove it, using a stripper for bearings.
3. To remove a lock ring (it is specified by arrows) fastenings of the bearing from the interior of a rotary fist.
4. If necessary, to establish an internal ring of the bearing back, and опирая an internal part of a rotary fist on supports and using tubular the mandrel, to squeeze out the bearing from a rotary fist.
5. To clear a nave and a rotary fist of a dirt and greasing.
6. To grease with a thin layer of greasing Molykote 321 R an external ring of the bearing and a plug flange.
7. It is reliable to fix a rotary fist on supports and to establish in it the bearing. Bearing installation to make with use tubular send which should press on an external ring of the bearing.
8. To fix the bearing a new lock ring which should be established in flutes in a rotary fist.
9. To establish the plug lateral aspect on a support and to establish an internal ring of the bearing on the end of a flange of the plug. Bearing installation to make using tubular the mandrel which presses on an internal ring of the bearing.
10. To establish a rotary fist together with a nave on the car.