Peugeot405
1. The maintenance instruction
2. Maintenance service
3. Engines
4. Fuel system
    4.1. Fuel system with the carburettor
    4.2. One-dot systems of injection of fuel
      4.2.1. Pressure removal in fuel system
      4.2.2. Adjustment of a cable of an accelerator
      4.2.3. The fuel pump
      4.2.4. An injector
      4.2.5. Check of system of injection of fuel
      4.2.6. Elements of system of injection Fenix
      4.2.7. Elements of system of injection Bosch Monopoint
      4.2.8. Elements of system of injection Magneti Marelli
    4.3. Multidot systems of injection of fuel
5. Systems of greasing, cooling
6. Release system
7. Coupling
8. Transmissions
9. Power shafts
10. A steering
11. Suspension brackets
12. Brake system
13. A body
14. An electric equipment


4.2.8. Elements of system of injection Magneti Marelli FUEL ATOMIZER

Removal

PERFORMANCE ORDER
1. To remove a wire of weight from the accumulator.
2. To remove the air filter.
3. To remove a socket of electroconducting of an injector (it is specified by an arrow).
4. To unscrew the fastening screw, to remove bracket and to take an injector from a casing together with ring consolidation.

FUEL REGULATOR OF PRESSURE

Removal
PERFORMANCE ORDER
1. To remove a wire of weight from the accumulator.
2. To remove the air filter.
3. To note position of a casing of a regulator, to unscrew four screws of fastening and to remove a casing, a spring and a diaphragm.

THE ENGINE OF MANAGEMENT OF THE IDLING MODE

Removal
PERFORMANCE ORDER
1. To remove a wire of weight from the accumulator.
2. To remove bracket and to disconnect a socket from the engine.
3. To unscrew two screws and to remove the engine of management of an idling mode.

POTENTIOMETER OF POSITION THROTTLE ЗАСЛОНКИ

Removal

PERFORMANCE ORDER
1. To remove a wire of weight from the accumulator.
2. To remove bracket and to disconnect a socket (it is specified by an arrow) from a potentiometer.
3. To unscrew two screws of fastening of a potentiometer and to remove it.

THE GAUGE OF TEMPERATURE OF ARRIVING AIR

The gauge of temperature of arriving air is screwed in from an injector underside, on the left side of a fuel atomizer.

Removal

PERFORMANCE ORDER
1. To remove a wire of weight from the accumulator.
2. To remove a socket and to unscrew the screw of fastening of the gauge and to take the gauge.
3. To unscrew three screws of fastening of a plastic ring and to remove from it consolidation.

ELEMENT OF HEATING OF THE INJECTOR

The element of heating of an injector is located before an injector.

Removal

PERFORMANCE ORDER
1. To remove a wire of weight from the accumulator.
2. To remove the air filter.
3. To remove a socket of electroconducting from the gauge of temperature of arriving air.
4. To unscrew screws and to remove a drive throttle заслонки.
5. To unscrew an element of heating and to take it from the case throttle заслонки.