Peugeot405
1. The maintenance instruction
2. Maintenance service
3. Engines
4. Fuel system
    4.1. Fuel system with the carburettor
    4.2. One-dot systems of injection of fuel
      4.2.1. Pressure removal in fuel system
      4.2.2. Adjustment of a cable of an accelerator
      4.2.3. The fuel pump
      4.2.4. An injector
      4.2.5. Check of system of injection of fuel
      4.2.6. Elements of system of injection Fenix
      4.2.7. Elements of system of injection Bosch Monopoint
      4.2.8. Elements of system of injection Magneti Marelli
    4.3. Multidot systems of injection of fuel
5. Systems of greasing, cooling
6. Release system
7. Coupling
8. Transmissions
9. Power shafts
10. A steering
11. Suspension brackets
12. Brake system
13. A body
14. An electric equipment


Enjoy high-quality streaming without any ads on Soap2day.

4.2.6. Elements of system of injection Fenix THE GAUGE OF POSITION THROTTLE ЗАСЛОНКИ

Removal

PERFORMANCE ORDER
1. To remove a wire of weight from the accumulator and contact of a wire to the gauge.
2. To unscrew two screws and to take the gauge.

FUEL ATOMIZER

Removal and installation
PERFORMANCE ORDER
1. To remove pressure in fuel system.
2. To remove a wire of weight from the accumulator.
3. To unscrew two bolts of fastening and to uncover the air filter.
4. To remove bracket fixings and a wire from atomizer contact.
5. To unscrew the fastening screw, to lift a clamp, and to take an atomizer.
6. At installation it is obligatory to replace a sealing ring.

THE REGULATING VALVE OF TURNS OF IDLING

Removal

PERFORMANCE ORDER
1. To remove a wire of weight from the accumulator.
2. To remove contact of a wire from the valve.
3. To weaken clips, and to remove two air hoses from the valve basis, marking their sites concerning a direction of the stream noted on the case of the valve.
4. To weaken two nuts and to take the valve.

PRESSURE REGULATOR

The pressure regulator is screwed by four screws on an injector.

THE GAUGE OF TEMPERATURE OF SOAKED UP AIR

The gauge is screwed in above in a final collector.

Removal

PERFORMANCE ORDER
1. To remove a wire of weight from the accumulator.
2. To remove contact of a wire from the gauge.
3. To unscrew the gauge and to remove it.

THE PRESSURE GAUGE IN THE INLET COLLECTOR

The gauge is established on a forward part.

Removal

PERFORMANCE ORDER
1. To remove a wire of weight from the accumulator.
2. To remove contact of a wire from the gauge.
3. To remove a vacuum hose from the gauge.
4. To unscrew two bolts of fastening and to remove the gauge.

THE GAUGE OF TEMPERATURE OF THE COOLING LIQUID

Removal

PERFORMANCE ORDER
1. To disconnect an electric socket from the gauge.
2. To merge cooling system.
3. To unscrew the gauge.

THE GAUGE OF POSITION AND FREQUENCY OF ROTATION OF THE ENGINE

Removal

PERFORMANCE ORDER
1. To remove wires from скоб fastenings.
2. To unscrew a bolt and to take the gauge from the engine.