Peugeot405
1. The maintenance instruction
   1.2. Controls, devices and the equipment
   1.3. Keys
   1.4. Pressure in tyres.
   1.5. Doors
   1.6. A mouth of a fuel tank, a luggage carrier, a cowl
   1.7. Seat belts
    1.8. Seats
   1.9. The panel of devices
   1.10. Illumination and the alarm system
   1.11. The proof-reader of light of headlights
   1.12. Washers and cleaners of glasses
   1.13. The additional equipment
   1.14. Comfort maintenance
    1.15. Internal heating and ventilation
   1.16. Combinations of devices
   1.17. Start of the petrol engine
   1.18. Start of the diesel engine
   1.19. Control bulbs and indexes
   1.20. A steering wheel, a gear change and a brake
   1.21. An automatic transmission
   1.22. Wheel replacement
   1.23. Towage
   1.24. Car identification
2. Maintenance service
3. Engines
4. Fuel system
5. Systems of greasing, cooling
6. Release system
7. Coupling
8. Transmissions
9. Power shafts
10. A steering
11. Suspension brackets
12. Brake system
13. A body
14. An electric equipment


1.22. Wheel replacement
THE GENERAL DATA



The jack and the handle (1) for it are in a compartment about a back wall (in versions with a body of type a sedan) or in the left back wing, behind a covering (in versions with a type body combi). Jack extraction (in versions with a type body combi) should move it forward to lift and involve behind. The spare wheel (3) is in a special basket (2) in the bottom of a back part of the car. From each party of the car there are two strengthened places (4) which serve also as a support for a jack.

Actions at wheel replacement

PERFORMANCE ORDER
1. Establish the car, whenever possible, on a flat and firm surface.
2. Tighten a manual brake and insert wedges under wheels of an opposite side of the car.
3. Include 1 or a reverse gear.
4. Take from a luggage carrier a jack and the handle for it.
5. Unscrew the handle a nut of fastening of a basket of a spare wheel.
6. Take a basket outside and release a hook.
7. Lower a basket.
8. Get a spare wheel.
9. By means of the handle remove a cap of a removed wheel.
10. The handle release screws of fastening of a removed wheel.
11. A jack head place under a place intended for a raising of the car (located about a removed wheel).
12. Check up that the jack head is placed under a necessary place, and lift the car a jack.
13. Unscrew four bolts and remove a wheel.
14. Establish a spare wheel and screw in by hand four bolts.
15. Screw up bolts a wrench not against the stop.
16. Lower the car, get a jack and definitively tighten bolts.
17. Insert a cap, establishing an aperture on a nipple in a corresponding place. Strike a palm for защелкивания hooks.
18. The removed wheel place in a basket so that its external surface has been turned top.
19. Lift a basket as it is possible above and hook on it.
20. In a luggage carrier screw up a fastening nut against the stop.
21. Place a jack and the handle in their nest.
22. Urgently repair the damaged wheel, pump up it to necessary pressure and dynamically balance.