7.4. Replacement of a cable of coupling Снятиеы

PERFORMANCE ORDER

1. If it is necessary, for access improvement to lift the receiver air givings in the engine or the case of the air filter. 2. To remove the accumulator and a platform for accumulator fastening. 3. In a motor compartment to disconnect a cable from the lever of deenergizing of coupling. 4. To disconnect a cover of a cable from картера transmissions (drawing at the left), and on early models it will be necessary to remove bracket blockings from a transmission suspension bracket (drawing on the right). If necessary, completely to weaken a counternut and a nut of a regulator from the end of a cable of coupling. 5. In the car to remove the bottom furnish of the panel of devices, and to disconnect plastic fastening of a cable to a coupling pedal. 6. To take a casing of a cover about a forward partition. 7. To release a cable from скоб fastenings, to take a cable from a partition of a motor compartment and to remove from the car.

Installation

PERFORMANCE ORDER

1. To place a casing on a cover and to check up, whether the plug in a flute of a tip of a cover is well fixed. 2. To establish a cover in an aperture of a forward partition and to hook on a cable with a coupling pedal. 3. To push against the stop a cover, completely to place the basic plug on a cover tip. 4. To arrange a cable in front of the stabilizer of cross-section stability, away from hoses of a heater and hoses of the amplifier of a steering. 5. To connect a cable to the angular intermediate lever about a transmission and to the lever of deenergizing of coupling. 6. To establish the accumulator and to adjust a course of a pedal of coupling as it is described in subsection 7.3.