Peugeot405
1. The maintenance instruction
2. Maintenance service
3. Engines
4. Fuel system
5. Systems of greasing, cooling
    5.1. Greasing system
    5.2. Cooling system
      5.2.1. Hoses of system of cooling
      5.2.2. A radiator
      5.2.3. The thermostat
      5.2.4. The fan of cooling of a radiator
      5.2.5. The pump of system of cooling
      5.2.6. Plums of a cooling liquid
      5.2.7. Pouring of a cooling liquid and removal of air from system
6. Release system
7. Coupling
8. Transmissions
9. Power shafts
10. A steering
11. Suspension brackets
12. Brake system
13. A body
14. An electric equipment


5.2.2. A radiator Removal

PERFORMANCE ORDER
1. To disconnect a negative wire from the accumulator.
2. At presence to disconnect a socket from the gauge of level of a cooling liquid established on the right side of a radiator.
3. At presence to disconnect a socket from the switch of the fan of the radiator established on the left side of a radiator.
4. To merge cooling liquid from cooling system.
5. To disconnect a fastening collar (drawing at the left) a branch pipe of giving of air and to remove a branch pipe of giving of air located over a radiator (drawing on the right).
6. At presence to disconnect a socket and a vacuum hose from gauge MAR located in the top part of a radiator, then to unscrew two bolts of fastening a suspension bracket of installation of the gauge and to remove the gauge.
7. To disconnect the top hose of a radiator from the left forward end of a radiator.
8. To disconnect the bottom hose of a radiator on the right side of a radiator. On some models for access to the bottom hoses of a radiator (are specified by arrows) it is necessary to remove a radiator lattice.
9. To remove two brackets fastenings of the top part of a radiator and to incline a radiator back.
10. Being careful to remove a radiator so that not to damage a radiator plate. Be attentive not to lose the bottom rubber support of a radiator.

Check

PERFORMANCE ORDER
1. If the radiator acted in film in connection with throughput reduction, to wash out its stream of water in two directions. Outside to blow a radiator the compressed air.
2. If the radiator proceeds, do not try to make or solder a leaking place since plastic details of a radiator will be damaged.
3. Insignificant негерметичность a radiator can be eliminated with use of hermetic of a radiator.
4. To check up a condition of the bottom rubber support of a radiator and if necessary replace them.

Installation

PERFORMANCE ORDER
Installation is made in sequence, return to removal, taking into account following moments:
      – To check up that the bottom ledges on a radiator are correctly established in a forward cross-beam;
      – At connection of hoses to a radiator to use new ring consolidations in connectors;
      – In summary to fill cooling system.