1. The maintenance instruction
2. Maintenance service
4. Fuel system
5. Systems of greasing, cooling
6. Release system
9. Power shafts
10. A steering
11. Suspension brackets
11.1. A forward suspension bracket
11.2. A back suspension bracket
11.2.1. A technical characteristics
11.2.2. Shock-absorber replacement
11.2.3. Replacement torsionов
11.2.4. The stabilizer
11.2.5. The suspension bracket lever
11.2.6. Removal and installation of a back suspension bracket
11.2.7. Adjustment of height of a suspension bracket of a body
11.2.8. Naves of back wheels
11.2.9. Features of a back suspension bracket of cars 4 х 4
11.2.10. Tank replacement
11.2.11. Removal and installation of the lever of a suspension bracket
11.2.12. Removal and installation of the cylinder of a suspension bracket
11.2.13. Removal of air from a hydraulic contour
11.2.14. Removal and pump installation
11.2.15. Removal and nave installation
12. Brake system
13. A body
14. An electric equipment
Back suspension bracket and the back bridge
||N – a stopper of level of oil,
V – a drain stopper of oil,
1 – an arm of the back bridge,
2 – the cylinder of a suspension bracket,
3 – a tank,
4 – a heat-shielding casing
Installation of an axis of the lever of a back suspension bracket
|1 – an axis,
2 – the lever,
3 – a tube,
|4 – the bearing,
5 – a lining,
6 – a sealing ring
| PERFORMANCE ORDER
| 1. To establish the car on the stationary lift.
|2. To remove the left facing of a luggage carrier.
| 3. To disconnect a socket (red) power supplies of the hydraulic pump (wire М326 and 326).
|4. To connect free plugs of a socket near to the button of installation of a suspension bracket in the top position.
|5. To reduce pressure so that suspension bracket cylinders it would be possible to move a hand.
|6. To remove полуось.
|7. To separate the pipeline of brake system from connection and from a latch.
|8. To remove a latch of the cylinder of a suspension bracket and a stabilizer flange.
|9. To unscrew a nut of an axis of the lever and to take an axis.
|10. To establish the lever in vertical position and to take it.
| PERFORMANCE ORDER
| Lever installation consists in performance of actions in return sequence in relation to removal process, thus it is necessary to remember greasing of an axis of the lever on all its length. It is necessary to establish new self-locking nuts, to remove air from back brakes and from a suspension bracket contour, to fill quantity of a brake liquid, and also liquid LHM, to necessary levels.